Kettler 2577 Installation guide

Made in the U.S.A.
www.kettlerusa.com
[email protected]
Copyright © Kettler USA 309.01
2577 18” Square Side Table
Contents:
(2) Legs
(1) Center Brace
(1) Table Top
(6) 1/4 - 20 x 2” Bolts
Tool Required:
#3 Phillips Head
Screwdriver
Assembly Instructions
1. Place leg inside the frame underneath the
table top aligning the predrilled holes. Insert
two 1/4-20 x 2” bolts then tighten them with the
phillips screwdriver. Repeat on the other side.
2. Place the center support brace vertically
between the legs aligning the predrilled holes.
Insert a 1/4-20 x 2” bolt thru the hole into the
center brace then tighten it with the phillips
screwdriver. Repeat on the other leg.
2.
1.
Aligning the predrilled holes on the leg with and
metal insert on the frame insert the bolt.

KETTLER® International Inc. • 1355 London Bridge Road • Virginia Beach, VA 23453
www.kettlerusa.com • [email protected]
Care & Maintenance
Ocean Comfort products are constructed from HDPE (High Density Polyethelene),
primarily a recycled material. UV inhibitors are also added to resist fading. Simply
maintain your furniture by cleaning with soap and warm water to ensure its long lasting
beauty. A soft bristle brush can be used on any tough to clean stains. Stainless steel
hardware is used in the assembly of these products and should be rinsed regularly with
fresh water if being used in a coastal environment.
KETTLER Limited Warranty
Ocean Comfort products are guaranteed for a period of 20 years (for residential use) and 5
years (for commercial use), starting from original purchase date. This warranty covers defects in
materials and/or workmanship and does not apply to the hardware.
Warranty not applicable to any products deemed as misused, abused or damaged due to an
uncontrollable act of nature.
*For Parts and Service, please contact us directly at 866-804-0440 or email [email protected]
Made in the U.S.A.