Keurig B100 Manual

Instructions for De-Scaling your Keurig B100Home Brewer with Vinegar
a. PREPARE
Step 1: Make sure you have at least 64 ounces of white vinegar on hand. You will
also need an empty sink and a ceramic mug (do not use a paper cup.)
Step 2: Turn power “OFF”, unplug Brewer and drain the Brewer following the
instructions below.
DRAINING YOUR KEURIG BREWER
CAUTION: Water is hot, please turn off brewer, unplug it and allow water to
cool before draining.
Step 1: Make sure Brewer is unplugged! Carry Brewer to sink making sure that it
stays upright.
Step 2: Remove the Drain Cap on rear of Brewer and, if present, remove Charcoal
Filter from the Water Fill Area.
Step 3: Rest the rear of the Brewer flat on the counter with the drain positioned
over the sink and allow Brewer to drain. For best results, do not tilt beyond a 90°
angle.
Step 4: Once water is drained, replace the Drain Cap.
b. FILL AND CLEAN
Step 1: Plug Brewer in and turn power “ON”.
Step 2: Pour approximately 64 oz of the vinegar into the Brewer until 4 beeps
signal the tank is full.
Step 3: Wait about 6 – 8 minutes for the vinegar to heat up and the green
“READY” light to go on.
Step 4: Place a ceramic mug in the Drip Tray and run a brew cycle. DO NOT USE
A K-CUP…just press the Brew button.
Step 5: Repeat the brew process 4 or 5 times pouring the contents of the mug
back into the Brewer after each cycle.
Step 6: Now let the Brewer stand for 4 hours while still on.
Step 7: Place a ceramic mug on the Drip Tray and run 4 brew cycles, pouring the
contents of the mug into the sink after each cycle.
Step 8: Turn the brewer off, let the remaining vinegar cool, and drain the brewer as
instructed above.
CAUTION: Vinegar may still be hot. Remember to replace the Drain Cap.
c. RINSE
Step 1: Fill the brewer with hot tap water.
Step 2: Power up brewer.
Step 3: Wait about 6-8 minutes for the water to heat up and the Green “Ready”
Light to go on.
Step 4: Place a ceramic mug on the Drip Tray and run a brew cycle.
Step 5: Repeat brew process 4 times for a total of 5 cycles.
Step 6: Drain the brewer as instructed above.
CAUTION: Water may be hot. Remember to replace the Drain Cap.
Step 7: You may need to rinse again to eliminate any residual taste.
For any additional questions regarding your B100 Single Cup Brewer, contact AT HOME
CUSTOMER SERVICE at 1-866-901-BREW (2739).