keyto KT-PRO545-V1 User manual

TECHNICAL SPECIFICATIONS
• Android 9.0
• CPU Model:MT6761D
• Quad core 1.8GHz
• LTE/UMTS/GSM/Wireless 2.4 & 5G /BT • 2GB RAM，16GB ROM
• LCD/CTP:5.45HD+
• Rear camera:5M AF
• BT 5.0
• Wireless 802.11a/b/g/n(2.4G/5G) • USB Type C
• Battery 4.2V/5200mAh
• Seiko Printer
• Barcode Scanner - E3 - 1D and 2D Barcodes
Product Safety Warnings
Use responsibly. Read all instructions and safety information before use to avoid injury.
The limit operating ambient temperature of the equipment declared by the manufacturer is
-15~55°C.
Battery Safety
Charge battery only at ambient temperatures ranging from 40°C.
CAUTION:Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type of battery recommended by the manufacturer. Dispose of used
batteries according to battery manufacturer’s instructions.
CAUTION:RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE.DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
CAUTION:Battery charging temperature maximum limit is 40°C.
Adapter Safety
During charging, please place the device in an environment that has anormal room
temperature and good ventilation. It is recommended to charge the device in an
environment with atemperature that ranges from 0°C~40°C.For altitude 2km below use
only.
Wireless Safety
Turn Wireless off in areas where Wi-Fi use is prohibited or when it may cause interference
or danger, such as in airplanes while flying.
Quick Start Guide
www.menastoretd.com
KT-PRO545-V1

Type-C USB
• Used for device charging and plug in OTG.
Headphone
• Insert a wired headset, and the sound will be switched from the speaker to the
headset.
MIC
• Used to make phone calls, video and voice conversations.
Speaker
• Used for listening to music or sound amplification.
Indicator Light
• Android Charging and Notification Indicator Lamp (Breathing Lamp) (Red, Green).
SD card slot and a SIM card slot, a SAM card slot
• Used to insert SIM card, SAM card and SD card.
Power Button
• Short Press: Light the screen, lock the screen.
Long press: In shutdown state, long press 2-3 seconds to turn on;
• When in use, press 2-3 seconds for a long time, and you can choose to Power off,
Restart or Screenshot.
• In the crash state, long press 10 seconds to restart automatically.
Volume Up Button
• Compatible with the functions of code scanning and volume up adjustment.
Volume Down Button
• Compatible with the functions of code scanning and volume down adjustment.
PRODUCT INTRODUCTION
Printing Instructions
This device supports 58mm thermal paper with the specifications of.
57±0.5mmφ40mm.
1. Open the printer cover;
2. Load the paper correctly into the printer as the direction shown above;
3 . Close the cover of the printer and finish.
Note: If the printed paper is blank, please check whether the paper roll has
been installed in the correct direction.