KFI HK-150 User manual

YAMAHA WOLVERINE
Plow Mount PART # 105695
Hardware Kit: HK-150
Kit Components:
Qty. Part Description
1................. Plow Mount Plate
2................. 3/8”-16 Square U-Bolt
2................. 3/8”-16 x 1” Flanged Bolt
4................. 3/8”-16 Nylock Flanged Nut
INSTALLATION INSTRUCTIONS:
1. Installyourwinchmountfollowingthe
instructionsprovidedwithyourmount.
 Note:Itiseasiertoinstalltheplowmountif
installedbeforethewinchandrollerfairlead.
2. Installtheplowmountplateusingthe1”anged
bolts,placingboltsthroughholes(A)inthewinch
mountplate.SeeFigure 2 and 3.
3. Usingtheplowmountasatemplatemarkanddrill
holesontheplasticskidplateasshowninFigure
4.
4. Removeplowmountplateanddrillholes.
5. Repeatstep2andreinstalltheplowmountplate.
Mark Drill Holes Mark Drill Holes
Figure 3: Install to winch mount.
Figure 4: Mount Plate Install
Figure 1
©2013 Copyright Kappers Fabricating, Inc. All rights reserved
This mount requires
KFI winch mount
#101515
A
Figure 2: Plow Mount Bolt Locations.

©2013 Copyright Kappers Fabricating, Inc. All rights reserved
Figure 5: U-bolt Install
6. InstalltheU-boltsovertheframeandthrough
theholesyoudrilled.Secureusingthe3/8”
angednuts.
7. Tightendownallbolts.
8. SeeUTVPlowTubeSysteminstructionmanual
fortubeattachment.
Figure 6: Fully Installed