KIBI F201 User manual

INSTALLATION GUIDE
Model: F201
DIMENSIONS
4 3/8 "
111( mm)
6 7/16 "
164( mm)
5 1/8 "
130( mm)
3 1/2 " 89( mm)
1 15/16Φ"
50( mm)
1 5/8Φ"
42( mm)
7 " 178( mm)
1 4/16”
(Φ32 mm)
2 7/16
(max 62 mm)
G1 1/4 Thread
2 7/16”
(Φ62 mm)
3 4/16”
(83 mm)
4 11/16”
(119 mm)

21
6
3 4
5
Connect and tighten the supply hoses by using two
adjustable wrenches (avoid twisting or kinking). Turn
on the angle valve and check for leaks.
Note: Do not remove the net lter that attached
into the connecting end!
From below the sink, Slide rubber washer, metal
washer and mounting bracket onto the thread shank.
Put the rubber O-ring into the bottom gap of
faucets then Insert faucet into faucet hole.
Remove the mounting hardware from the
mounting pipe.
Shut o water suppliers. Remove the old faucet, clean
the mounting surface.
Note: For rst time install, ush the pipes rst by
open the angel valve to run 60s.
Adjust position of faucet body if necessary,
Then tighten the mounting nuts with phillips
screwdriver until snug.
FAUCET INSTALLATION

21
3 4
Install waste system (not included) and check for
leakage.
Screw tail piece onto drain using the tail washer.
Insert thick silicone washer and hard washer over the
exposed mail threaded area and screw drain nut onto
drain. Do not overtighten.
Remove all components from drain piece including:
thin and thick silicone washer, hard washer, drain nut
and tail piece.
Insert drain and thin silicone washer into basin. Apply
Teon to the exposed male threading area of drain
piece.
POP-UP INSTALLATION

Problem Cause Action
Low ow Aerator or iter may be clogged Unscrew aerator to check rubber packing or replace aerator.
(Note: some models require wrench to remove aerator.)
Faucet leaks from under
handle
Bonnet nut has come loose or
cartridge needs to be reseated
Remove handle and cap. Using a wrench, ensure bonnet nut is
tight.
Water will not shut o
completely.
Dirty or worn out plastic washer in
the cartridge.
Adjust or replace cartridge.
WARNING: Failure to securely tighten bonnet nut with a wrench
could result in water damage.
TROUBLE SHOOTING
CLEANING AND CARE
Our Kitchen and bathroom products are made of solid brass to comply with the needs of the market with regard to
design and functionality. To avoid damage to the product, it is necessary to take proper care of it.
Clean the faucet often with a soft cloth to keep it looking like new. For heavy cleaning you can use mild liquid deter-
gents or non-abrasive liquid polisher. Rinse with water and dry with a soft cloth. Avoid abrasive cleaners, steel wool
and harsh chemicals as these will dull the nish and void your warranty.
If you’ve followed the instructions carefully and your faucet still does not work properly, take these corrective steps.