Kilner Fridge Dispenser User manual

1. When rst receiving
your Kilner® Fridge
Dispenser, the spigot/
tap will be loose for safe
transit. This must be
tightened before use.
2. Wash with warm soapy water before use. After lling the dispenser with liquid,
the lid needs to be securely fastened carefully to ensure there are no leaks or drips.
3. Tighten the spigot
carefully ensuring it is
positioned 90 degrees to
the Kilner® logo.
4. Hand tightening
is adequate. Over-
tightening will cause the
silicone washer to buckle
and distort. This will
cause the spigot/tap
to drip.
O
O
PP
P
P

5. Make sure the silicone
ring on the underside
of the lid is at and not
distorted. Over-tightening
the washer on the spigot/
tap can cause the silicone
ring to distort.
6. Carefully place the
lid on the mouth of the
dispenser by holding the
seal towards the lid. The
seal needs to sit at on the
mouth of the glass and not
fall inside the dispenser.
7. Place a downward
pressure on the lid as you
turn the screw band, this
will ensure a tight seal.
Tighten securely by hand.
8. Make sure the spigot/
tap is turned to the closed
position, central on the
lid and facing the correct
direction.
A helpful video showing this process is available on www.kilnerjar.co.uk
O
O
O
P
P
P