KING CUSTOMER CARE: kingliving.com/support
3The Nimbus has a plastic protector over the arms of the recliner mechanism to cover potential
pinch points in the moving components of the recliner. The plastic protector on the side of the
mechanism may have come loose and is being detected by the safety system. Follow these steps:
1. Turn power OFF at the power socket for each recliner module.
2. Check that the two pins of the protector are securely attached to the recliner mechanism. If this
protector has come loose and is hanging down, it may be activating the chairs safety system and
will need to be re-attached. For more information contact King Customer Care.
QWhy can’t my recliner module’s memory positions be programmed or recalled?
The power to your recliner module may have been interrupted and therefore the home position
needs to be reset. Follow these steps:
1. Touch and hold buttons 3 and 4 for 15 seconds. NOTE: It is important to touch the buttons for the
full 15 seconds.
2. If your memory positions still cannot be set or recalled, contact King Customer Care.
Disable the Obstruction Detection Safety Feature
If the footrest is stuck in the open position, it can be manually operated by temporarily disabling the
footrest safety of the recliner module. Please note: this disables the obstruction detection safety feature.
Important: Always check for obstructions before disabling the obstruction detection safety feature.
To Disable The Obstruction Detection Of The Cloud V:
1. Press & hold buttons 1 & 4 for 30 seconds.
2. Release buttons - obstruction detection function is disabled.
You can manually open/close recliner.
To Reset Cloud V To Factory Default:
1. Disconnect power supply for 5 seconds.
2. Reconnect to power supply & switch on.
The Cloud V is now reset to factory default and the
safety function restored.
123
4
10
