KingSmith WalkingPad WPC1F User manual

Manufacturer : Beijing Kingsmith Technology Co.,Ltd.
Address : Floor 4, Building 25, Area 18, ABP Park, Fengtai, Beijing, China.
After-sale service email : [email protected]
Made in China Model No. : WPC1F

User Manual
DANGER – To reduce the risk of electric shock: Always unplug this appliance from the electrical outlet immediately
after using and before cleaning.
WARNING – To reduce the risk of burns, fire, electric shock, or injury to persons: 1) An appliance should never be
left unattended when plugged in. Unplug from outlet when not in use, and before putting on or taking off parts. 2) Close super-
vision is necessary when this appliance is used by, on, or near children, invalids, or disabled persons. 3) Use this appliance
only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. 4) Never
operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or
dropped into water. Return the appliance to a service center for examination and repair. 5) Do not carry this appliance by
supply cord or use cord as a handle. 6) Keep the cord away from heated surfaces. 7) Never drop or insert any object into any
opening. 8) Do not use outdoors. 9) Do not operate where aerosol (spray) products are being used or where oxygen is being
administered. 10) To disconnect, turn all controls to the off position, then remove plug from outlet.
Connect this appliance to a properly grounded outlet only. See Grounding Instructions.
This appliance is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsi-
ble for their safety. Keep children under the age of 13 away from this machine.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not change the plug in any way.
To reduce the risk of personal injury, read and understand all the instructions before using this product.
WARNING
Manufacturer : Beijing Kingsmith Technology Co.,Ltd.
Address : Floor 4, Building 25, Area 18, ABP Park, Fengtai, Beijing, China.
After-sale service email : [email protected]
Made in China

Contents
1. Product and Accessories
2. Functional Schematic Diagram
3. Guide for Initial Operation
4. Learn to Use WalkingPad
5. Safety Notice
6. Maintenance and Service
7. Trademark and Legal Declaration
8. Replacement and Disposal
02
03
07
09
13
16
17
18
User Manual
Make sure that the product is connected to an outlet having the same configuration as the plug. No adapter should be used
with this product.

Thank you for choosing the WalkingPad Walking device, hereinafter referred to as a WalkingPad, which possess various advantages
including exquisite, foldable, innovative integral design. From now on, enjoy the quality life of walking at home.
Please carefully check whether the contents of the package are complete and intact. If there is any missing or damaged, please contact
the seller.
Performance &indicators
Working dimensions
Folding dimensions
Walking Area
Gross weight
Net weight
Maximum load
Applicable age
Applicable height
Minimum speed
Maximum speed
Power Input
Frequency
Rated voltage
Sport mode Main Product
Other accessoriesParts
Detailed parameters
1432 x547 x129mm
56.5'' x 21.5'' x 5''
822 x 547 x 129 mm
32.5" x 21.5" x 5"
1200 x 415 mm
47" x 16.5"
25 kg / 55 Ibs
22 kg / 48 lbs
100 kg / 220 lbs
14 ~ 60 years old
Unlimited
0.5 km/hr 0.5 mi/hr
6 km/hr 3.7 mi/hr
746 W
60 Hz
220 - 240 V ~
Standby mode/ Manual
mode/ Automatic mode
Remote Control Lanyard Wrench Silicone OilPower Cord
User Manual
01 02
1. Product and AccessoriesWelcome to use

1. Product main body
03 04
2. Functional Schematic Diagram
Walking Belt
Fold Hinge
Roller
Power Switch
Power Plug
Power Light
Roller

Display Time Display Speed Display Distance Display Steps
Standby Mode Manual Mode Automatic Mode
2. lntroduction of the function of the indicator panel 3. WalkingPad remote control
05 06
START/STOP
HANING HOLE
ACCELERATION
DECELERATION
MODE SWITCH
DISPLAY SCREEN
BATTERY COVER
2. Functional Schematic Diagram

07 08
1. Choose flat ground to place the
WalkingPad. It is forbidden to place it
on thick and soft cushion. Please note:
Don't connect the power before the
WalkingPad is fully unfolded.
4. Connect the power cord and press
the button to switch on.
2. Unfold the walkingpad slowly and
press it down to completely flat.
3. Check and adjust the walking belt
to make sure it's centered.
10. If the belt deviates from the orbit in
use, please adjust properly.
SEE: 06 Maintenance and Service.
5. Search ''WalkingPad" App from
Apple Store or Google Play and
complete installation.
6. Open the App, follow the prompts
to set up the device.
8. Complete Novice Guide to unlock
all Functions ( maximum speed
6km/h 3.7 mi/hr ). Otherwise the
speed limit remains at 3km/h 1.7
mi/hr.
7. Enter Novice Guide. 9. Start to use the WalkingPad.
3. Guide for Initial Operation

1. Mode instructions 2. Instructions of the standby mode control 3. Instructions of manual mode control (primary mode)
09 10
Standby Mode
Light of the Standby mode is on;
Motor and sensor stop responding.
Manual Mode
Light of the manual mode is on;
Control the speed through the remote
control or APP.
Automatic Mode
Light of the automatic mode is on;
Speed is automatically controlled by
intelligent algorithm.
It follows the speed of walking.
The motor and sensor stop responding in this mode to
prevent nonusers from accidentally triggering the
WalkingPad.
In this mode, the speed of the WalkingPad can be controlled by the remote control. It is recom-
mended that beginners use the manual mode first and then use the automatic mode after being
skilled in using the WalkingPad. The manual mode is controlled by remote control by default, that
is, the START/STOP button of the remote control is used to start or stop the WalkingPad, which
can be modified in the client "Personalized".
Mode Switch
Short press: return to the previous mode.
Standby Mode Manual Mode
MODE SWITCH
Short press: switch to automatic mode.
Long press: switch to Standby mode.
ACCELERATION
Short press: increase speed by 0.25 mi/hr.
START/STOP
Short press: Start or Stop the WalkingPad.
DECELERATION
Short press: reduce speed by 0.25 mi/hr.
4. Learn to Use WalkingPad
In the manual mode,
set as the intelligent
start and stop, the
WalkingPad will start
automatically to the
target speed (default is
1.7 mi/hr ) while
entering this area.

Short press: stop the WalkingPad.
Mode Switch:
Short press: switch to manual mode.
Long press: switch to Standby mode.
4. Description of automatic mode control (advance mode)
11 12
This is a challenging and higher-class mode, User can walk on the Walkingpad
completely out of remote controller. We only recommend those who have good
sports skills or walking-device experience to take the challenge.
Automatic mode
4. Learn to Use WalkingPad
Entering this area, the
WalkingPad will start
or accelerate under
the automatic mode.
Entering this area, the
WalkingPad will slow
down automatically
under the automatic
mode.
5. Remote Control Notice
If the remote control has no response or you change a
new one, the remote controller and walking device need
to re-establish communication.
Remote control pairing method:
Restart the WalkingPad, press and hold down the mode
switch button on the remote control immediately, hearing
the sound of "Beep" indicates the success of pairing.
Note: During the operation, the remote control should be
close to the WalkingPad.
6. Error code
The error code is off when the walking machine is work-
ing normally. When error occurs, the display panel of
remote shows the error code.
E01: Drive communication fault.
E02: Motor abnormalities.
E05: Overcurrent protection.
E06: Motor protection.
E08: Sensor fault.
E09: Controller connection failure.
E10: High temperature protection, automatic recovery
after the end of countdown.
E11: Overload protection, please add lubricating oil, and
resume automatically after countdown.

13 14
Please keep a rear distance of
1000 mm or more.
Please keep a distance of 500 mm
or more for both sides.
Please choose sport shoes. Please do not stand on the
walking machine when it is
under auto calibration situation.
Anti-pinch.
Anti-involved, please do not
trample.
Unplug the power cord when the
it’ s not in use.
Using on uneven ground is
prohibited.
It is strictly prohibited to walk
up and down the walking
machine when running.
Turn the power off before fold up
the WalkingPad.
Prohibition of vertical placement.
Prohibition of lateral placement.
5. Safety Notice

1. Clean the walking machine • Turn off the machine and unplug the power cord.
•Add several drops of detergent on cotton rag or towel. Don't pour the detergent on the belt
directly, and don't use acid or corrosive cleaners.
• Wipe off dust and stains on the frame, front panel and belt. Do not wipe backside of the belt.
•After using for a period, dust and stains may appear on the back part, that is normal and just
clean them up.
• Press and hold both Mode Switch Button and Acceleration Button on the remote control over
3 seconds.
• The walking belt will move at the speed of 4 km/hr ( 2.5 mi/hr ).
• Running belt inclined left: Turn the left adjustment screw 1/4 circle clockwise.
• Running belt inclined right: Turn the right adjustment screw 1/4.circle clockwise.
• Slipping running belt: Turn the left and right adjustment screws clockwise at the same time a
half circle.
• Run the running belt for a period of time (1~2 minutes) to observe the centering situation. If
necessary, please adjust it again.
• Turn off the machine and unplug the power cord.
• Lift up the belt and apply silicone oil on the backside of the belt.
• Power on the treadmill again to run the running belt at 4km/hr ( 2.5 mi/hr ) for 10-20 seconds.
• 5-10 ml of silicone oil is needed for one time of lubrication.
• If the lubrication is applied too much, the belt will slip and affect normal use.
• Add the silicone oil every 3 months.
6. Maintenance and Service
15 16
Children should be
supervised to ensure that
they do not play with the
Walkingpad.
Please use it carefully
for elders and
pregnant women.
Please keep your sight
horizontal to avoid dizziness.
More than one person
on the Walkingpad is
prohibited.
Using machine with
pet is prohibited.
Walking sideways on
the machine is
prohibited.
Walking backwards on
the machine is
prohibited.
Trampling the machine
head is prohibited.
Horizontal sight
2. Adjust the belt
3. Lubricate the Belt
5. Safety Notice

Beijing Kingsmith Technology Co., Ltd holds the patents of Walkingpad Walking Device series products. Kingsmith edits and
owns the copyright of this manual book. Without Kingsmith's written permission, any form of unauthorized distribution, reproduc-
tion, publication, release or quotation by any institution or individual is prohibited. This manual contains as many as possible of
all the functions and instructions for use. However, due to product imperfections, design changes, etc., the description may still
have discrepancies with what you have purchased. In view of product updates, description in this manual book may differ from
what you have purchased in color, appearance, etc. Actual supplies prevail. This appliance is not intended for persons (including
children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance. Children aged from 8 years and above and persons can use this
appliance with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understood the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Product performance standard : Q/FTSMS0001-2017
17 18
8. Replacement and Disposal7. Trademark and Legal Declaration
The battery contained in this appliance must be removed for or disposal.
When replacing the battery, use only original battery, available from the parts shop.
The battery can be replaced by open the back cover, be aware of the polar mark while inserting a new battery.
Never dispose of old battery in domestic garbage, but only through the proper public collection points. This also
applies to the battery of defective appliances.

8. Replacement and Disposal
Devices marked with this symbol must be disposed of separately from your household waste, as they contain
valuable materials which can be recycled. Proper disposal protects the environment and human health. Your
local authority or retailer can provide information on the matter.
19