KingSmith WalkingPad WPS1F User manual

KingSmith WalkingPad
Walking device
Model: WPS1F
User Manual • Uživatelský manuál •
Užívateľský manuál • Használati utasítás •
Benutzerhandbuch

2
English
3 –21
Čeština
22 –40
Slovenčina
41 –59
Magyar
60 –78
Deutsch
79 –97

3
The product user guide contains product features, how to use, and the operating
procedure. Read the user manual carefully to get the best experience and avoid
unnecessary damage. Keep this manual for future reference. If you have any questions
or comments about the device, please contact the customer line.
✉www.alza.co.uk/kontakt
✆[phone]
Importer Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7, www.alza.cz

4
Important safety instructions
The appliance is intended for household.
DANGER –To reduce the risk of electric shock:
Always unplug this appliance from the electrical outlet immediately after using
and before cleaning.
WARNING –To reduce the risk of burns, fire, electric shock, or injury to persons:
1) An appliance should never be left unattended when plugged in. Unplug from outlet
when not in use, and before putting on or taking off parts.
2) Close supervision is necessary when this appliance is used by, on, or near children,
invalids, or disabled persons
3) Use this appliance only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
4) Never operate this appliance if it has a damaged cord or plug, if it’s not working
properly, if it’s has been dropped or damaged, or dropped into water. Return the
appliance to a service centre for examination and repair.
5) Do not carry this appliance by supply cord or use cord as a handle.
6) Keep the cord away from heated surfaces.
7) Never drop or insert any object into any opening.
8) Do not use outdoors.
9) Do not operate where aerosol (spray) products are being used or where oxygen is
being administered.
10)To disconnect, turn all controls to the off position, then remove plug from outlet.

5
WARNING
1. This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory, or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
2. Correct Disposal of this product. This marking indicates that this product should not
be disposed with other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your
used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmentally
safe recycling.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
WARNING –always keep young children away from this machine. Contact with the
moving surface may result in severe friction burns.

6
Welcome to use!
Thanks for choosing KingSmith WalkingPad Walking device, and hereinafter referred to
as “a WalkingPad”, which possess various advantages including exquisite, foldable,
innovative integral design. From now on, enjoy the quality life of walking at home.
Performance & indicators
Detailed parameters
Expansion dimension
1445 × 518 × 125 mm
56.9” × 20.4” × 4.9”
Folding dimensions
825 × 518 × 136 mm
32.5” × 20.4” × 5.4”
Walking area
1200 × 400 mm
47” × 15.7”
Net weight
25 kg (55 lbs)
Maximum load
100 kg (240 lbs)
Applicable age
14 ~ 60 years old
Applicable height
Unlimited
Minimum speed
0.5 km/hr 0.5 mi/hr
Maximum speed
6 km/hr 3.7 mi/hr
Power input
735 W
Frequency
50/60 Hz
Rated voltage
220 - 240 V ~
Sport Mode
Standby mode / Manual mode /
Automatic mode

7
Product and accessories
Please check carefully if the items inside the packaging are complete and intact. In case
of any item missing or it’s broken, please contact the seller.
Accessories
Power cord
Remote
control
Remote control lanyard
Main product
Hex L Shaped
Wrench
Silicone oil
User Manual

8
Function schematic diagram
1. Product main body
Left side
Right side
2. Introduction of the function of the indicator panel
Walking Belt
Fold Hinge
Display Panel
Touch
Roller
Power Switch
Power Plug
Roller
Display Time
Display Speed
Display Distance
Display Calories
Display Steps
Manual Mode
Fault Warning Light
Automatic Mode

9
3. WalkingPad remote control
Start/stop
Lanyard
Acceleration
Deceleration
Mode Switch
Battery type
(1 * “CR2032“)
Battery cover

10
Guide for initial
1. Choose flat ground to place the WalkingPad. It is forbidden to place it on thick and soft
cushion. Please note: Don’t connect the power before the WalkingPad is fully unfolded.
2. Unfold the WalkingPad slowly and press it down to completely flat.
3. Check and adjust the walking belt to make sure it’s centered.

11
4. Connect the power cord and press the button to switch on.
5. Unlock all functions by following two ways, otherwise the speed
limit remains at 3 km/hr (1.9 mi/hr):
1) Walk 1 km (0.6 mi) on device first, reboot to unlock all functions.
2) Complete novice guide by “KS Fit” APP to unlock all functions.
6. Search “KS Fit” APP from Apple Store or Google Play and complete installation.
7. Open APP, follow the prompts to set
up the device.
8. Enter novice guide to unlock all
functions.

12
9. Start to use the Walking Pad.
10. If the belt deviates from the orbit in use,
please adjust properly. SEE: 06
Maintenance and service.
Learn to use WalkingPad
1. Mode instruction
Manual Mode
Light of the manual mode is on;
Control the speed through
the remote control or APP.
Automatic Mode
Light of the automatic mode is on;
Speed is automatically controlled by
intelligent algorithm. It follows
the speed of walking.
2. Instructions of the standby mode control
The motor and sensor stop responding in this mode to prevent nonusers from
accidentally triggering the WalkingPad.
Mode Switch
Short press: return to the previous mode

13
3. Instructions of manual mode control (primary mode)
Manual mode
In this mode, the speed of the WalkingPad can be controlled by the remote control. It
is recommended when beginners use the manual mode for first time and then use
the automatic mode after being skilled in using the WalkingPad. The manual mode
is controlled by remote control is used to start or stop the WalkingPad, which can
be modified in the client “Personalized”.
Mode Switch
Short press: switch to automatic mode
Long press: switch to standby mode
Acceleration
Short press: increase speed by 0.5 km/h (0.5 mi/h)
Start/stop
Short press: start or stop the WalkingPad
Deceleration
Short press: reduce speed by 0.5 km/h (0.5 mi/h)
In the manual mode,
set as the intelligent
start and stop, the
WalkingPad will start
automatically to the
target speed while
entering this area.

14
4. Description of automatic mode control (advance mode)
Automatic
This mode is a challenging and higher-class mode. User can walk on the
WalkingPad completely out of remote controller. We only recommend those who have
good sports skills or walking-device experience to take the challenge.
5. Remote controller notice
If the remote controller has no response or you change a new one, the remote
controller and walking device need re-establish communication.
Remote control pairing method:
Restart the WalkingPad, press and hold down the mode switch button on the remote
control immediately, hearing the sound of “Beep” indicates the success of pairing.
Note: During the operation, the remote control should be close to the LED display
panel of WalkingPad.
Entering this area,
the WalkingPad will
start or accelerate
under the
automatic mode.
Entering this area,
the WalkingPad will
slow down
automatically under
the automatic mode.
Mode Switch
Short press: switch to manual mode
Long press: switch to standby mode

15
6. Error warning light
Error Warning Light on the display panel is off when WalkingPad works well. When error
occurs, error warning light turns on and shows its error code.
E01:
Upper control receives lower
control data abnormally
E08
Motor overvoltage protection
E02:
Hall fault
E09
Motor phase loss protection
E03:
Software overcurrent protection
E10
Motor overload loss protection
E04:
Locked rotor protection
E20
Abnormal communication
E05:
The data received by the lower
control is abnormal
E21
Sensor failure
E06:
Hardware overcurrent protection
E07:
Motor undervoltage protection
Safety notice
Please keep a rear distance of
1000 mm or more.
Please keep a distance of 500 mm
or more for both sides.

16
Please use sport shoes.
Using on uneven ground is
prohibited.
Please do not stand up on the
walking machine when it is
under auto calibration
situation.
It is strictly forbidden to walk up
and down on WalkingPad while
walking. When emergency occurs,
please press the remote control
START/STOP and step away from
the WalkingPad from one side.
Anti-pinch.
Anti-involved, please do not
trample.
START/STOP

17
Do not bring pets when you are
using the Treadmill.
Do not use the Treadmill
backward or sideways.
Prohibition of vertical
placement.
Prohibition of lateral
placement.
Please keep your sight horizontal
to avoid dizziness.
Children should be supervised
to ensure that they do not play
with WalkingPad.
More than one person on the
WalkingPad is prohibited.
Walking sideways on the
machine is prohibited.
Horizon

18
Using machine with pet is
prohibited.
Walking backwards on the
machine is prohibited.
Trampling the machine head is
prohibited.
Please use this product
reasonably according to your
physical condition (the elderly
and pregnant women should
use it cautiously). If you feel
unwell, stop exercising
immediately. If necessary,
please seek medical attention.

19
Maintenance and adjustments
1. Clean the walking machine
•Turn off the machine and unplug the
power cord.
•Add several drops of detergent on cotton
rag or towel. Don’t pout the detergent on
the belt directly, and don’t use acid or
corrosive cleaners.
After using for a period, dust and stains
may appear on the back part, that is
normal situation, then just clean them up.
2. Adjust the belt
•Press and hold both mode switch button
and acceleration button on the remote
control over 3 seconds.
•Front panel shows “CALI”, and the speed is
4 km/hr (2.5 mi/hr).
•If belt deviates to the left: Turn the left
adjusting screw for a half-circle clockwise.
•If belt deviates to the right: Turn the right
adjusting screw for a half-circle clockwise.
•If belt is slipping: Turn both left and right
adjusting screw for a half-circle clockwise
at same time.
•Keep the machine running for 1-2 minutes
and check whether it needs to readjust.
3. Lubricate the belt
•Turn off the machine and unplug the
power cord.
•Lift the belt and apply silicone oil on the
backside of the belt.
•Turn on the machine again.
•Keep the machine running under 4 km/hr
(2.5 mi/hr) for 10-20 seconds.
•Only apply 5-10 ml lubricant oil each time,
too much lubricant oil makes the belt
become slipping.
•Apply for silicone oil once every 3 months.

20
Warranty Conditions
A new product purchased in the Alza.cz sales network is guaranteed for 2 years. If you
need repair or other services during the warranty period, contact the product seller
directly, you must provide the original proof of purchase with the date of purchase.
The following are considered to be a conflict with the warranty conditions, for
which the claimed claim may not be recognized:
•Using the product for any purpose other than that for which the product is intended
or failing to follow the instructions for maintenance, operation and service of the
product.
•Damage to the product by a natural disaster, the intervention of an unauthorized
person or mechanically through the fault of the buyer (e.g. during transport, cleaning
by inappropriate means, etc.).
•Natural wear and aging of consumables or components during use (such as
batteries, etc.).
•Exposure to adverse external influences, such as sunlight and other radiation or
electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage,
electrostatic discharge voltage (including lightning), faulty supply or input voltage and
inappropriate polarity of this voltage, chemical processes such as used power
supplies, etc.
•If anyone has made modifications, modifications, alterations to the design or
adaptation to change or extend the functions of the product compared to the
purchased design or use of non-original components.