KitchenAid KHTU105L User instructions

PRODUCT MODEL NUMBERS OVERALL DIMENSIONS
VENTING REQUIREMENTS
KHTU105L
KHTU105R
KHTU165R
Electrical: 120-volt, 60-Hz, AC-only, 15-amp.
electrical supply. Use copper wire only. A time-
delay fuse or circuit breaker and separate circuit is
recommended.
30" and 36" Canopy Range Hood
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 9760927 Rev. A
07-19-05
®
14 ⁷⁄₈"
(37.8 cm)
5 ⁷⁄₈" (14.9 cm) diam.
exhaust collar
10 ⁵⁄₁₆"
(26.2 cm)
19 ¹⁄₂"
(49.5 cm)
29 ⁷⁄₈" (75.9 cm) - 30" (76.2 cm) model
35 ⁷⁄₈" (91.1 cm) - 36" (91.4 cm) model
mountingscrews
locations (4)
centerline
of hood
1³⁄₈ "
(3.5 cm)
13 ¹⁄₂" (34.3 cm) - 30" (76.2 cm) model
16 ¹⁄₂" (41.9 cm) - 36" (91.4 cm) model
8¹⁄₁₆"
(20.5 cm)
5⁷⁄₈"
(14.9 cm)
diam.
10 ⁹⁄₁₆"
(26.8 cm)
⁷⁄₈"
(2.2 mm)
centerline of
exhaust collar
4"
(10.2 cm)
30" (76.2 cm) or
36" (91.4 cm) min.
cabinet openingwidth
24" (61 cm) min.
30" (76.2 cm)
suggested max.
bottom of hood to
cookingsurface
18" (45.7 cm)
min. clearance
upper cabinet
to countertop
36" (91.4 cm)
base cabinet
height
13" (33 cm)
cabinet depth
70 ⁵⁄₁₆"
(178.6 cm)
min.
76 ⁵⁄₁₆"
(193.8 cm)
max.
to bottom of
cabinet frame
CABINET OPENING DIMENSIONS
Example vent system
Vent piece 6" (15.2 cm) round
45° elbow 2.5 ft (0.8 m)
90° elbow 5.0 ft (1.5 m)
Maximum length = 35 ft (10.7 m)
1-90° elbow = 5 ft (1.5 m)
8 ft (2.4 m) straight = 8 ft (2.4 m)
1 - wall cap = 0 ft (0 m)
System length = 13 ft (3.9 m)
90˚ elbow
2 ft
(0.6 m)
6 ft (1.8 m)
wall cap
This range hood is factory set for vented installations. Vent system can
terminate through either the roof or wall. A 6" (15.2 cm) round vent
system must be used. The vent system length should not exceed
35 ft (10.7 m).
To calculate the length of the system you need, add the equivalent feet
(meters) for each vent piece used in the system.