Kiwitron ETS Instruction manual


ETS quick start manual







 



Placement

The card reader (ETS-UP) device must be in an easy to reach location as the              
driver needs to use it to unlock the truck before use.

For the best shock detection, we advise to place the IO expansion (ETS-DN)            
firmly connected to the truck frame and perpendicular with the ground and           
the moving direction.

Avoid installing the ETS in environmentally hard location such as close to           
strong heat sources or exposed to the elements (although the ETS is IP65).
Also be aware not to place the card reader (ETS-UP) close to metallic objects             
which can prevent the wireless transmissions.












Pinout



X1 connector pinout
Position
Function
1
Power input positive (10 - 120 Volts DC)
2
Power input negative
3
Digital input IP1 (positive activation threshold >1,7 Volts - 150 Volts max)
4
Digital input IP2 (positive activation threshold >1,7 Volts - 150 Volts max)
5
Analog input (0 - 10 Volts)
6
Digital input IN1 (negative activation threshold < 0,5 Volts - 150 Volts max)
7
Digital input IN2 (negative activation threshold < 0,5 Volts - 150 Volts max)
8
Relais 1 - common contact
9
Relais 1 - normally open contact (6Amp max)
10
Relais 2 - common contact
11
Relais 2 - normally open contact (6Amp max)
12
Relais 3 - common contact
13
Relais 3 - normally open contact (6Amp max)
14
Analog input AIN1 (0 - 5Volts) (used for current sensor)




X2 connector pinout
Position
Function
1
Power output positive (5 Volts DC)
2
Power output negative
3
CAN +
4
CAN -
Canbus line on X2 connector has line closure resistor (120 ohm)




Connection diagram example

 



Software setup
Only few steps are needed to configure the device. Download and install the
PC software from www.kiwitron.it/ets

Connect the USB cable and start the ETS software.

Shock sensor calibration
Go to “Settings → Advanced → Accelerometer” and configure the mounting position     
according to the drawings.
Click  “Save” and then  “0 Accelerometer”.




Battery percent sensor calibration
Go to “Settings → System → Battery” and change the  “Elements” field according to the     
number of elements present in the truck battery (e.g.: a 48 Volts battery has 24
battery elements).
Click  “Save”.
Battery current sensor calibration
Go to “Settings → System → Battery”. Ensure the truck is ON and that no actuation is    
in progress then click  “0 Current sensor”.

 



Badge configuration
Go to  “Users” . Click the green button to configure a new driver. When
prompted, choose  “Wizard”  to start the guided badge configuration.
Insert a driver name and click  “Next”.  Put the badge on the reader (in front for
ETS device; on the left side for ETS Touch device). The badge code shall
appear on the PC screen. Click  “Next”  until the wizard ends.
Insert any other driver desired using the same procedure.
Click  “Send to device”  to save the user list (important!).


 



Close a relay contact on shock detection
Go to “Settings → Signals→ ETS”.   

