Klavis Mixwitch User manual

SUPPORT & ADDITIONAL INFO
The complete users manual is available on:
www.klavis.com/support
Contact us: [email protected]
MW-V2 - Copyright 2019 - Diagonal Electronics
INSTALLATION
Versions of the Mixwitch with a 16-pin connector require a 5V
rail in your case, those with a 10-pin connector do not.
Ensure that there is enough power left to supply this module.
Beware of the orientation; the stripe on the ribbon cable
should match a similar stripe for the –12 (minus 12 Volts)
indication on your supply board connector.
Supply rail Current draw
(10-pin)
Current draw
(16-pin)
+12V 39 mA22 mA
- 12V 24 mA26 mA
+5V 0 mA13 mA
READ ME FIRST
Mixwitch
Mixer / switcher
Klavis

SWITCHER MODES
USAGE & PANEL
The Mixwitch combines a pair
of 2>1 mixers, also useable
as a single 4>1 mixer.
A sequential switch can be
activated to select one of four
inputs or only one of the two
inputs of the second mixer.
Inputs are selected by a clock
or a voltage.
Muting and polarity are done
by click-less switching.
When set to Log, a mixer sees
its pots curve fit for audio
purposes and its gain reduced
by 6dB to avoid clipping.
All settings are memorized
over power cycle.
The switcher runs at audio
rate. The manual describes
many applications for
waveshaping, sequencing,
sub-octaves generator, granu-
lar synthesis, and more.
Mixwitch
Mixer & switcher
A1 A2
Switcher
CV
Clk
B
CV/Clk
B1 B2
In B1 In B2 B
In A1 In A2 A
Klavis
Off
Log
Log
Off
Switcher mode LEDs on Details
CV Clk B
Off Switcher is disabled - Mixers operate normally CV, 4 channel •Selects one of four inputs or none according
to a voltage. (1 volt steps) 0 to 4V = none, A1, A2, B1, B2
Clock, 4 channel •Clock/trigger calls each input sequentially in a
loop.
Clock, 4 channel, random
blink Clock/trigger calls four inputs randomly; never
calls the same input twice in a row
CV, 2 channel (B) ••Selects one of 2 inputs of mixer B or none
according to a voltage. (1 volt steps) 0 to 2V = none, B1, B2 Mixer A is unaffected
Clock, 2 channel (B)
••Each clock pulse alternates between input B1
and B2 Mixer A is unaffected