Knox KN-TW01 User manual

Knox KN-TW01 Towel Warmer
Instruction Manual

Index
IndexIndex
Index
Safety Precautions……………………………………………………………………….Page 1
General Operation Instructions……………………………………………………Page 1
General
General General
General Operation
OperationOperation
Operation
Wall-Mounting or Floor-Standing
1. Assembly Instructions (Wall-Mounting)
a. Screw the mounting brackets into the wall. (see diagram for hole positions
b. Snap the towel warmer into place using the supplied mounting clamps.
2. Assembly Instructions (Floor-Standing)
a. Simply attach the included feet onto the warmer per the diagram below.
Caution:
•Be careful not to touch the towel rods during operation and for some time
afterwards as they may be too hot.
•This is an electrical device. Do not immerse in, or use near, water.
•In case of accidental immersion in water, immediately unplug the power cord.
•Unplug the towel warmer when not in use.
•Do not operate if the power cord or appliance shows signs of damage or if the
warmer is malfunctioning.
•Make sure to plug the warmer into a grounded electrical socket.
•Never allow children to use the towel warmer unsupervised.

peration
1. Plug the towel warmer into a 120 volt electrical outlet
2. Allow the towel warmer to heat up for several minutes.
a. Make sure to place towels onto the warmer immediately to keep heat from
dissipating.
3. Please Note: Damp or wet towels can bleed and cause discoloration in the finish of the
Towel Warmer if the material isn’t colorfast.