KoamTac KDC475 User manual

KDC470/475 Pistol Grip
Assembly Manual
• 1 x KDC470/KDC475 Pistol Grip Adapter
• 1 x Pistol Grip
• 1 x Li-ion Battery (
6000mAh)
• 4 x screws + 1 extra
*KDC470/475 sold separately.
Tweezers and PH0 screwdriver (not included)
will be necessary to complete assembly.
• 1-Slot Charging Cradle
• Extended Battery
Additional KDC470/475 Accessories:
What’s in the Box?
Assembly Instructions:
1. Using tweezers, carefully remove all four (4) screw caps
from back of KDC470/475. (A)
2. Remove all four (4) screws from back of KDC470/475. (B)
3. Remove cover plate from back of KDC470/475. (C)
4. Align screw holes of Pistol Grip Adapter with screw holes
of KDC470/475. Use four (4) included screws to attach
Pistol Grip Adapter to KDC470/475.
5. Align notch in top of Pistol Grip with top notch
of the Pistol Grip Adapter. (E)
6. Slide Pistol Grip up until it clicks. (F)

Pistol Grip Battery Status KDC475 with Pistol Grip
*Assembly procedure is the same as KDC470.
*The LED (Light Emitting Diode) blinks when the battery
is being used .
1. Turn knob on the bottom of the Pistol Grip
counter-clockwise to open the battery door. (H)
3. Close the battery door and turn the battery door knob
clockwise to lock. (J)
2. Insert the battery into the Pistol Grip. (I)
When the device is charging
When the battery is in use and
device is discharging
KDC475
IH
J
Assembled View
Removing Pistol Grip
Squeeze tabs on both sides of the Pistol Grip Adapter
and slide the Pistol Grip down. Pull the Pistol Grip away
from the Pistol Grip Adapter and KDC470/475.
6000mAh Li-ion Battery Installation
Red: Low Battery
Orange: Charging
Green: Fully Charged
Blinking Red: Low Battery
Blinking Orange: Discharging
Blinking Green: Fully Charged