Kodak Photo Printer 6850 User manual

KODAK Photo Printer 6850
User Guide

Eastman Kodak Company
343 State Street
Rochester, New York 14650
© Eastman Kodak Company, 2011
Kodak is a trademark of Eastman Kodak Company.
ENERGY STAR is a U.S. registered trademark.
Part Number 4J7961_US

November 2011 1
Safety and Regulatory Information
Important Safety Information
CAUTION:
Use of controls or adjustments, or performance of
procedures other than those specified in this manual may
result in injury and/or damage to the printer.
• The power outlet should be easily accessible and installed
near the printer.
• Position the power cable so that it cannot be pulled on or
tripped over.
• Never allow the power cable to contact hot surfaces.
• The power outlet must be grounded. An ungrounded outlet
can cause fire, electric shock, or harmful interference to
nearby electrical devices.
• Use only the power cable provided with the printer.
• Do not operate the printer with a damaged power cable.
• Always unplug the power cable from the printer before
cleaning or when the printer is not in use.
• If the printer has been dropped or damaged, be sure a
qualified service person examines the printer before you use
it.
• Do not block the filter openings on the printer cabinet.
• Do not expose the printer to moisture or water.
• Do not allow any foreign objects or liquids to fall or spill inside
the printer. Fire or electric shock could result.
• The thermal head becomes extremely hot during normal
operation. Do not touch it.
• Alcohol pads are used to clean the thermal head and other
internal printer components. In the United States for health,
safety, and environment information, call 585-722-5151.
Customers outside the U.S. can contact their local KODAK
Service Representative.

2November 2011
Safety Labels
Please observe the important safety warnings that are posted on
the printer.
This label is posted behind the trim tray.
CAUTION HOT SURFACE
To avoid burns, use caution when closing the cover.
CAUTION HOT SURFACE
The thermal head becomes extremely hot
during normal operation. Do not touch it.
CAUTION SHARP OBJECTS
The metal edges of the printer may be sharp.
CAUTION SHARP CUTTER BLADE
There are sharp cutter blades inside the printer. Do not
insert hands or objects.
P/N 2J5439
1641132233
P/N 2J5452
1641132183
P/N 2J5451
1641132182

November 2011 3
Regulatory and Safety Compliance
Safety
Complies with UL 60950-1:2006 Third Edition—CAN/CSA C22.2
No. 60950-1-03
EN 60950-1:2006+A11:2009
IEC 60950-1:2005 2nd Edition
Tested for Norwegian IT Power systems 240V phase to phase
Electromagnetic Compatibility (EMC)
NOTE: This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15
of the FCC rules. These limits are designed to provide
reasonable protection against interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
interference to radio communications. Operation of this
equipment in a residential area is likely to cause
interference in which case the user will be required to
correct the interference at his or her own expense.
Requirements of the EMC directive 89/336/EEC were met
through compliance with the following:
• EN 55022: 94 (class A) with Amendments A1:95 and A2:97
• EN 55024: 98 ITE Immunity includes the following:
EN 61000-4-2 ESD
EN 61000-4-3 Radiated RF immunity
EN 61000-4-4 EFT
EN 61000-4-5 Surge
EN 61000-4-6 Conducted RF immunity
EN 61000-4-11 Voltage dips and interruptions
• EN 61000-3-2 Harmonics
• EN 61000-3-3 Flicker
CAUTION:
This is a class A product. In a domestic environment this
product may cause radio interference in which case the user
may be required to take adequate measures.
“Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.”
This is a Class A product based on the standard of the Voluntary

4November 2011
Control Council for Interference from Information Technology
Equipment (VCCI). If this is used near a radio or television
receiver in a domestic environment, it may cause radio
interference. Install and use the equipment according to the
instruction manual.
Noise Emission
The operator-position noise emission value is less than 70 dB(A).*
* Average value specified in accordance to JIS Z8731
Disposal
This product contains a small amount of lead in the solder on the
circuit boards. Disposal of this material may be regulated due to
environmental considerations. For disposal or recycling
information, please contact your local authorities. In the USA,
contact the Electronics Industry Alliance at www.eiae.org.
In the European Union, this symbol indicates that
when the last user wishes to discard this product,
it must be sent to appropriate facilities for recovery
and recycling. Contact your local KODAK
Representative or refer to
www.kodak.com/go/recycle for additional
information on the collection and recovery
programs available for this product.

Product Overview
November 2011 i
A161_3004AC
Rear
8
12
9
7
10
11
1
2
4
6
3
Front
1. Filter openings
2. Cover release
3. Upper cover
4. Operator panel
5. Print exit slot (print catcher not shown)
8. Paper door
9. Data plate (location may vary)
10. Serial number/Bar code label
11. Power connector
7. USB connector
5
6. Trim tray
12. Power switch
(location may vary)

ii November 2011
Product Overview
Internal View with Ribbon Installed
1
2
1. Thermal head
2. Stripper plate
Internal View with Ribbon Removed
3
5
4
3. Cleaning roller, rear
4. Platen roller
5. Cleaning roller, front

Product Overview
November 2011 iii
Kodak
Photo Printer 6850
Power
Ready
Error
Rewind/Clear
Paper
Enter
Paper
AdvanceMenu
Operator Panel