Kodak I1220 - Document Scanner Operator's manual

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 1
SCEIS Imaging: Kodak i1220 Scanner
Installation and Configuration Guide
If your scanner is already installed, go to the CONFIGURATION section on page 3.
Configuration will set the scanner to ignore blank pages.
INSTALLATION
TWAIN Driver Installation
1. Install the Kodak twain driver from the installation disk or download the most current driver version from:
http://graphics.kodak.com/docimaging/US/en/Products/Document_Scanners/Desktop/i1220_Scanner/Support/
Drivers_And_Downloads/i1200_Plus_Series_Scanner_Drivers/index.htm
The serial number of the scanner is required for the driver download. The serial number is located on the bottom of
the scanner.
Enable Citrix Access to the Scanner
2. Log in to Citrix (sceisgateway.sc.gov) and log in to either SAP or OnBase, it does not matter which one.
3. Right-click on the Citrix Connection icon in the system tray, located near the time in the lower right corner of the
screen. Left-click on ‘Open Connection Center’.
Click ‘Scanner Security’

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 2
Click ‘Yes’ and ‘Never Ask Me Again’ then ‘OK’
Click ‘OK’ to close the Citrix Connection Center

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 3
CONFIGURATION
On your Windows main screen…
Go to Start >> Programs >> Kodak >> Document Imaging >> Scan Validation Tool
Select ‘TWAIN’
Click ‘OK’
Wait while the connection to the scanner is made.

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 4
Select the ‘Setup’icon
Select ‘Default’ or ‘SCEIS Default’ if it is listed
Select ‘Two Sided’
Click ‘Settings’

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 5
Select each tab and make the settings identical to the screenshots
GENERAL TAB

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 6
In the ‘Side’ field on the General tab the word ‘Both’ should be grayed out.
If it says ‘Front’ or ‘Back’ instead of ‘Both’ click the ‘Advanced Image Setup’ icon
Select ‘Two Sided’
Uncheck ‘Different settings per side’
Click ‘Done’

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 7
SIZE TAB

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 8
ADJUSTMENTS TAB

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 9
ENHANCEMENTS TAB
Important

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 10
When you are done with all of the Image tabs (General / Size / Adjustments / Enhancements)…
Click the ‘Device’ button at the bottom of the screen.
DEVICE SCREENS
Select each tab and make the settings identical to the screenshots
GENERAL TAB