Kogan KAWLM65TLTA User manual

Tilt Adjustable Wall Mount for 32” ~ 65” TVs
KAWLM65TLTA
Quick tart Guide
Caution
This product contains small items that could be a choking hazard if swallowed.
Keep these items away from young children.
•Make sure these instructions are read and completely understood before
attempting installation. If you are unsure of any part of the installation,
please contact a professional installer for assistance.
•The wall or mounting surface must be capable of supporting the
combined weight of the mount and the display, otherwise the structure
must be reinforced.
•Safety gear and proper tools must be used. A minimum of two people are
re uired for this installation. Failure to use safety gear may result in
property damage, injury or death.
•Please ensure children do not play with the mount or the mounted
television at any time.
•Please check the mount every two months to ensure that bolts and screws
are tight, and that the wall behind the mount appears to be in good
condition.
This product was designed to be installed on solid concrete walls.
Before installing, make sure the wall will support the combined load of the
e uipment and hardware.
Never exceed the maximum load capacity of 45kg, or it may result in product
failure or personal injury.
Note: this product is intended for indoor use only. Use of this product outdoors
could lead to product failure or personal injury.

Item Checklist
What's in the box
M4 x 10mm
A (4 pcs)
M5 x 12mm
B (4 pcs)
M5 x 16mm
C (4 pcs)
M6 x 12mm
D (4 pcs)
M6 x 16mm
E (4 pcs)
M6 x 20mm
F (4 pcs)
M5 Washer
G (8 pcs)
M8 x 60mm
B1 (6 pcs)
M10 x 50mm
B2 (6 pcs)
M8 Washer
B3 (6 pcs) Magnetic removable
bubble level
M6 box wrench M8 box wrench
4 x 4
allen key
5 x 5
allen key
Tools required
Mounting
tep 1-A ( olid concrete mounting)
Wall Plate

tep 1-B Wood stud mounting
tep 2 tep 3 Attaching brackets to creen
•If using A, B, C please use G.
•If using D, E, F please don't use G.
Note: If the TV hole pattern is larger than the TV plate, you are re uired to use
the extension plates to install.

tep 4 Hanging the TV onto the wall plate
•Tighten the screw into the holes of the bottom bracket.
•Tighten or loosen the screw nuts on the head of the wall plate to adjust
the tilting function.
•Tighten or loosen the M6 screw nuts on the head of the wall plate to keep
level.
tep 5
Cable management clip
Cable routing access points

Product Diagram
If you require any additional information regarding the mount or require
assistance in regards to a warranty claim, please contact the Kogan customer
support team.