Kogan KAWLMFM90MA User manual

KOGAN UNIVERSAL
EXTENDABLE CEILING
PROJECTOR MOUNT BRACKET
KAWLMFM90MA

Read the entire instruction manual before you start installation and assembly. If you have
any questions regarding any of the instructions or warnings, contact your local distributor for
assistance.
CAUTION: Use with products heavier than the rated weights indicated may result in
instability causing possible injury.
•Please closely follow the assembly instructions. Improper installation may result in
damage or serious personal injury.
•Safety gear and proper tools must be used. This product should only be installed by
professionals.
•This product is designed to be installed on wood joist ceiling or concrete ceiling.
•Make sure that the supporting surface will safely support the combined weight of the
equipment and all attached hardware and components.
•Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
•This product contains small items that could be a choking hazard if swallowed. Keep
these items away from children.
•This product is intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury.
•Never exceed the maximum load capacity of 20kg or it may result in product failure or
personal injury.
IMPORTANT: Ensure that you have received all parts according to the component checklist
prior to installation. If any parts are missing or faulty, contact your place of purchase for a
replacement.
MAINTENANCE: Check that the product is secure and safe to use at regular intervals (at
least every three months).
SAFETY & WARNINGS

A(x1) D(x1)
B(x1)
C(x1)
E(x1)
M-A (x6)
M5 x 10
M-B (x4)
M6 x 10
M-C (x4)
M5 x 8
M-D (x4)
M4 x 8
M-E (x4)
M3 x 8
M-F (x4)
D3
M-G (x4)
D4
M-H (x10)
D5
M-I (x2)
D5
M-J (x4)
D6
M-K (x1)
4mm
M-L (x1)
5mm
M-M (x4)
94mm
W-A Screw
ST6.3 x 55 (x4)
W-B Anchor
(x4)
W-C Washer
D8 (x4)
Tools required for installation (not supplied)
Phillips head
screwdriver Stud finder Pencil Drill
COMPONENTS

Step 1
Using the 5mm Allen key (M-L), loosen the arm (B) screw to separate the upper and lower
pieces.
Step 2
Using a Phillips head screwdriver (not supplied) loosen the three screws on the lower arm
and remove the backing plate. This will allow easier access to thread power and AV cables.
PREPARING THE MOUNT

Step 3
Once all cables are in position, replace the backing plate and tighten the three screws. Then
return the lower arm back within the upper arm.

Step 4
With the cables in place, attach the ceiling bracket (A) and projector mount (C) to the arm
assembly with their respective washer and screw pairings (M-B, M-J and M-A, M-H as
shown below).

Using a pencil, mark the desired position for the mount on your ceiling, using the mount to
serve as a stencil for the hole positions. If mounting on wood joist ceiling, use a stud finder
first to check positions of joists and ensure the position is free from electrical wiring. Using a
drill, create the pilot holes. Secure with screws and washers (W-A, W-C). Pencil, stud finder
and drill not supplied.
Wood joist ceiling:Use a ø4.5mm or 3/16” drill bit, drilling 55mm deep. Do not use anchors.
Concrete ceiling:Use a ø10mm or 3/8” drill bit, drilling 60mm deep. Use anchors (W-B).
INSTALLING MOUNT

Align the bracket (D) with your projector’s VESA holes and secure using supplied screws (M-
C, M-D, or M-E) and washers (M-F, M-G, or M-H) depending on required length. Insert M-M
extension brackets if required for your projector. Use a Phillips head screwdriver (not supplied)
to tighten screws.
SECURING PROJECTOR TO MOUNT

Using the 5mm Allen key (M-L), set the arm assembly’s length. Hook the projector (with
bracket installed) onto the mount (C). Two people should lift the projector to prevent
damage. Once in place, secure the bracket into place using the M-A screw and washers (M-
H, M-I).

Tighten the mount at the desired angle using the M-K Allen key to lock mount into position.

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com