Kogan KA600CDSTVA User manual

KA600CDSTVA
600W Corded 2-in-1
Stick Vacuum

Table of Contents
Safety & Warnings..................................................................................................................1
Product Overview..................................................................................................................2
Assembly.................................................................................................................................2
O eration.................................................................................................................................3
Cleaning and Care.................................................................................................................3
Troubleshooting.....................................................................................................................4
Safety & Warnings
• Read all instructions before using the a liance
• Before the first o eration, make sure the dust cu or the dust bag is ro erly
installed.
• Only use the vacuum cleaner indoors on dry surfaces and kee the area your
cleaning well lit.
• Don’t use this vacuum cleaner if it has been dro ed, damaged or left
outdoors.
• Don’t handle the lug or use the vacuum cleaner with wet hands.
• Don’t ull or carry this vacuum cleaner by the ower cord. Don’t use the
ower cord as a handle, ull the ower cord around corners, shar edges or
close a door over the Power cord. Don’t un lug vacuum cleaner by ulling on
the ower cord.
• Don’t vacuum u any flammable or combustible materials (lighter fluid,
etrol, kerosene etc.) or use the vacuum cleaner in an area with ex losive
va ours or liquid.
• Don’t vacuum u hot coals, cigarette butts, matches or smoking hot burning
items or use in an area where there may be harmful fluids (chlorine, bleach, and
ammonia drain cleaner).
• Don’t attem t to remove blockages with shar objects as this may cause
damage to your vacuum cleaner.
• Don’t attem t to remove blockages with shar objects as this may cause
damage to your vacuum cleaner.
• If abnormal noise, smell, smoke or any other failure or breakage, including any
issue with the ower cord is found during the o eration, cease use immediately
and contact Kogan Su ort.
• This a liance is not intended for use by ersons (including children) with
reduced hysical, sensory or mental ca abilities, or lack of ex erience and
knowledge, unless they have been given su ervision or instruction concerning
use of the a liance by a erson res onsible for their safety.
• Children should be su ervised to ensure that they do not lay with the
a liance.
1

Product Overview
1. Handle
2. To electric cord storage holder
3. Detachable rod handle
4. Power cord
5. Air outlet o enings
6. Dust com artment
7. Dust filter (inside dust com artment)
8. Unlocking button for dust
com artment
9. On/O switch
10. Rod handle connector
11. Bottom electric cord storage holder
12. Crevice accessory
13. Floor nozzle attachment
14. Suction o ening
15. Handheld vacuum unit
Assembly
Main unit
Conversion from handheld to floor vacuum cleaner
Remove all arts from the ackaging and lace carefully on
a flat area. If necessary, ut rotective sheeting underneath
to avoid harm to easily damaged surfaces. Carefully remove
all acking materials and ensure there are no missing arts.
Using as a handheld vacuum cleaner
The a liance is ready for use as a handheld
a liance as soon as it has been un acked.
Using as a floor vacuum cleaner
• O en the small fla on the handle of the handheld vacuum unit.
• Insert the rod handle connector in the o ening in the handheld vacuum unit
and ush in as far as it will go.
• Press the fla against the connector so that it sna s into lace.
Removing rod handle
• O en the fla .
• Pull out the rod handle.
• Close the fla on the handle again.
2

Fitting and removing nozzles
CAUTION: Always switch o the vacuum cleaner before changing nozzles.
• To fit nozzles, insert in the suction o ening.
• To remove nozzles, ull out of the suction o ening.
Floor Nozzle Attachment
The floor nozzle attachment is suitable for both car ets and
smooth floors.
Crevice Accessory
The crevice accessory is designed for u holstery, cleaning the
interior of cars and for getting into all corners and cracks that
are inaccessible with the floor nozzle attachment or without a
nozzle.
CAUTION: Never hold the crevice nozzle close to the body or it may stick to the
skin, and cause injury.
If the nozzle does get stuck, set the switch o immediately.
O eration
• Ensure all arts are fully assembled and filters correctly inserted before use.
• Do not use the a liance on the following:
– liquids or wet materials (e. g. car et sham oo when wet)
– ash, cigarette ends, matches, etc.
– combustible or in flammable substances
– very fine dust (e. g. concrete dust) or toner
– hard, ointed objects such as large s linters of glass
1. Fit or remove the rod handle according to desired use.
2. To quickly unwind the cable from the floor vacuum cleaner,
twist down the cord holder on the to handle.
3. Insert the ower lug in a wall outlet and turn on.
4. Begin cleaning
5. After use, switch o and un lug.
6. After use, always em ty the dust com artment and clean the
dust filter.
Cleaning and Care
• Remove the ower lug before cleaning and/or utting away.
• Do not use caustic or abrasive roducts or you may damage the surface.
• Never immerse the a liance in water.
Em tying and cleaning the dust container
1. Hold down the unlock button for the dust com artment and
carefully remove.
3

2. Hold over a bin, carefully remove the dust filter and em ty.
3. Ta the dust filter gently.
4. Occasionally wash the dust filter under cold running water.
CAUTION: Do not wash the dust filter in the washing machine.
5. Leave the dust filter to air dry for 24 hours until com letely dry
before reinserting.
CAUTION: Do not use a hair dryer.
6. Press firmly back in so it fits tightly in the dust com artment
housing.
CAUTION: Never use the vacuum cleaner without the dust filter inserted.
7. Press the unlocking button to engage. The dust cu must be securely
engaged at the to and bottom of the a liance for it to work ro erly.
Cleaning and re lacing motor rotection filter
Once you have removed the dust cu , you will find a iece of non-
woven material on the o en side of the a liance. This is the motor
rotection filter. It needs to be cleaned from time to time.
1. Remove from the a liance, shake and ta o the dust.
2. Rinse with lukewarm water.
3. Shake again and leave to dry o com letely.
Cleaning housing
Clean the housing with a slightly dam , soft cloth if
necessary.
Storage
• The ower cord can be wra ed around the rod handle is fitted.
• To unwind next use, twist the cord holder down on the to handle.
• The vacuum cleaner should be stored indoors in a cool, dry lace.
Troubleshooting
IMPORTANT: If you are ex eriencing any issue with the a liance whatsoever,
first ins ect the filters and all arts of the brush head carefully and ensure there
is no buildu of dust or dirt.
This is the most common cause of vacuum cleaner faults and roblems,
including owering on and suction strength.
If you ex erience any issues, contact Kogan Su ort.
User manual is subject to change without notice. For the latest version of your user manual,
lease visit htt s://www.kogan.com/usermanuals/
4