Instr 9926678 Rev 01 06/15Page 5 of 7
Warnings:
Always use CAUTION when operating any ATV/UTV with accessories or additional implements secured to
the ATV/UTV.
DO NOT allow any passengers on the ATV/UTV.
Excessive speeds can cause serious injuries or death. DO NOT exceed 5 mph when the “Polaris 3-Point
Hitch” or any accessories are secured to your ATV/UTV.
Keep hands and feet away from all “Polaris 3-Point Hitch” parts and implements.
DO NOT use the “Polaris 3-Point Hitch” or any of its implements to carry a person.
Follow manufactures maximum recommended towing capacities for yourATV/UTV.
Stay away from all moving parts.
Additional weight may be needed on the ATV/UTV to help provide proper weight distribution to the wheels for
safety. Add weight to the opposite end of theATV/UTV of which the “Polaris 3-Point Hitch” is secured.
DO NOT place yourself or any parts of your body under, between or on any part of the “Polaris 3-Point Hitch”
or its implements.
Use CAUTION when removing and replacing either the “Polaris 3-Point Hitch” or its implements, they are
heavy. Assistance may be required.
As with any accessory secured to an ATV/UTV, additional weight from the “Polaris 3-Point Hitch” and its
implements can reduce steering, breaking and overall handling of your ATV/UTV. Allow for increased
breaking distances when stopping. Steering will be affected and it is advised to reduce speeds when doing
any turning. Failure to use caution could result in an injury or death.
DO NOT traverse on terrain that contains steep grades, as the ATV/UTV could overturn causing injury or
death.
General Use and Maintenance:
With proper care the Polaris Disc will give you many years of dependable service. After use we recommend
that you clean off any mud, dirt or debris that might have accumulated on your implement. As with any
ground engaging implement, paint scratches and worn paint will be evident after its first use. We recommend
painting exposed bare metal surfaces with any type of black spray paint intended for metal objects. Use of
moisture displacing oils such as “WD-40” should keep the implement from rusting also.
Disc Plows (or “Disc Harrows” as they are sometimes called) are typically not used to “turn over” new ground,
and it is recommended that if you have purchased the Disc Plow for new soil preparation that you allow extra
time for working the soil to gain the desired results in the end. Disc Plows will cut established turf, but will
require additional passes. We recommend removing as much of the grass and over growth as possible.
When you get started, start with shallow cuts in the soil until you get a feel for how deep your ATV/UTV can
handle cutting without over working yourATV/UTV’s engine. You are better to make multiple cuts over the
same area, than to try to make a single pass at a very deep cutting depth. This process of multiple passes
will also result in better ground preparation and seed germination.
The 14” Notched Discs are specially heat treated and sharpened to provide a durable cutting edge. You may
experience a chipped disc edge at times; however, this doesn’t affect the Discs’ ability to cut. If a disc should
“break” Polaris recommends that you replace it immediately to prevent damage to the bearings or the main
disc assembly.
