Kompernass TOUCH IT KH 4112 User manual

KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM
www.kompernass.com
ID-Nr.: KH4112_14-05/09-V2
“TOUCH IT” TABLE LAMP
KH 4113
KH 4112 KH 4114
6
“TOUCH IT” TABLE LAMP
Operating instructions
CV_KH4112_14_33345_LB6.qxd 10.06.2009 14:32 Uhr Seite 1

q
e
w
t
r
q
e
w
r
KH4112 KH4114
q
e
w
t
r
t
y
KH4113
CV_KH4112_14_33345_LB6.qxd 10.06.2009 14:32 Uhr Seite 5

- 1 -
“TOUCH IT”
TABLE LAMP
KH 4112/13/14
Read these operating instructions carefully before
using the appliance for the first time and preserve
this maual for later reference. Pass this manual on to
whoever might acquire the appliance at a future
date.
1. Safety instructions
Danger:
Should moisture/water permeate into the table
lamp, …
• there is the danger of receiving an electric
shock!
• it may be irreparably damaged!
Thus:
Do not use or store the table lamp …
• in a humid environment!
• in close proximity to water! Additionally, never
subject the table lamp to spray water or rain.
NEVER place receptacles filled with water or
other fluids, for example flower vases, on the
table lamp!
Risk of Burns!
Hot surfaces. NEVER touch the lamp shade when
the appliance is in use.
Risk of personal injury!
• Remove the table lamp plug from the wall power
socket before changing the bulb. If the table lamp
was previously switched on: allow the table lamp,
and the bulb that is to be replaced, to first cool
down for at least half an hour.
• Arrange for defective power plugs and/or cables
to be replaced at once by qualified technicians
or our Customer Service Department.
• Clean the table lamp only after you have first
withdrawn the plug from the wall power socket.
Otherwise, there is the great risk of receiving an
electric shock!
• Lay the power cable in such a way that no one
can tread on or trip over it.
• This appliance is not intended for use by indivi-
duals (including children) with restricted physical,
physiological or intellectual abilities or deficiences
in experience and/or knowledge unless they are
supervised by a person responsible for their safety
or receive from this person instruction in how the
appliance is to be used.
• Children should be supervised to ensure that
they do not play with the appliance..
Beware of appliance damage!
• The table lamp can be irreparably damaged if
it tips over or falls down! For this reason, always
place the table lamp on a solid, level, slip-proof
surface.
• Use only light bulbs that match the specifications
detailed in these operating instructions.
• Do not use an extension cable. The appliance
plug must be easily accessible in the event of an
emergency.
Risk of fire!
The table lamp and the bulb will become hot
when it is in use!
Thus:
• Do not cover the table lamp while it is switched
on. Also, do not hang any objects over the table
lamp.
• Do not place any easily inflammable/combustible
materials in the immediate vicinity of the table
lamp while it is switched on.
IB_KH4112_14_33345_LB6 10.06.2009 14:42 Uhr Seite 1

Note:
For damage resulting from …
• opening of the table lamp base / the transformer
housing
• attempted repairs made by non-qualified personnel
• improper use of the table lamp
no liability/warranty is accepted!
2. Proper Use
The table lamp is intended exclusively …
• as an illumination and decorative object for interior
rooms (no damp rooms)
• for domestic, non-commercial use.
3. Items supplied
Table lamp
Operating instructions
4. Technical data
Power supply: 230-240 V ~50Hz
Power consumption : 40 W
Bulb: 40W 230V E14
Protection class: II
5. Controls
1Bulb (not supplied)
2Lamp shade
3Socket
4Base with touch sensor as on/off switch
and dimmer
5Power cable
6Covering cap (KH4113 only)
6. Select a suitable
installation site
Always place the table lamp on a solid, level, slip-
proof surface.
To avoid malfunctioning, do not place the table
lamp on metallic surfaces.
Do not place any easily inflammable/combustible
materials in the immediate vicinity of the table lamp
while it is switched on. Do not cover the table lamp
while it is switched on. Also, do not hang any ob-
jects over the table lamp.
Do not place the table lamp on metallic objects.
Otherwise there is a risk of a
short-circuit or fire!
7. Preparing the table lamp
for use
1. Carefully remove the table lamp from the packa-
ging.
2. KH 4112/KH 4114: Screw the light bulb 1
(not supplied) into the bulb holder 3.
3. KH 4113: Carefully remove the lampshade 2
upwards from the table lamp. Loosen the cove-
ring cap 6from the table lamp. Screw the bulb
1(not supplied) into the bulb socket 3. Repla-
ce the lampshade 2back onto the table lamp.
Secure it with the help of the covering cap 6.
4. Unwind the power cable 5to its full length.
Insert the power cable 5into a power plug.
The table lamp is now ready for use.
8. Using the table lamp
• Switch the table lamp on by touching the base 4
with a finger (KH4113: touch the base 4or the
stand).The table lamp now lights up at the lowest
brightness level.
- 2 -
IB_KH4112_14_33345_LB6 10.06.2009 14:42 Uhr Seite 2

- 3 -
• To switch it to the second brightness level: touch
the base 4a second time.
• To switch it on to the third brightness level: Touch
the base 4once again.
• To switch the table lamp off: touch the base 4
once again.
If you do not wish to use the table lamp for an ex-
tended period of time: Remove the power cable 5
from the power socket. To avoid damage, be care-
ful not to kink the power 5cable.
9. Changing the light bulb
Should the bulb 1in the table lamp be defect, it
must be exchanged for a new one. Additionally:
• Remove the power cable 5of the table lamp
from the power socket.
If the table lamp was previously switched on: Allow
the lamp shade 2and the light bulb 1at least a
half-hour to cool down before you continue.
The risk of burns is ever present!
• KH 4112/KH 4114: Screw the light bulb 1out
of the bulb holder 3in an anti-clockwise direction.
• KH 4113: Loosen the covering cap 6. Careful-
ly remove the lampshade 2upwards from the
table lamp. Then screw the old light bulb 1out
of the bulb holder 3.
• Screw a new light bulb 1into the bulb holder 3.
Use exclusively light bulbs of the type E14, 40 W.
• KH 4113: Replace the lampshade 2onto the
table lamp. Secure it with the help of the cove-
ring cap 6.
• Insert the power cable 5into a power socket.
The table lamp is once again ready for use.
10. Cleaning the table lamp
Before cleaning the table lamp, always remove its
power cable from the power socket.
Clean the table lamp exclusively with a slightly
damp cloth. Ensure that no moisture can permeate
into the lamp!
Otherwise, there is the great risk of
receiving an electric shock!
11. Troubleshooting
Problem
The table lamp does not function.
Possible causes / solutions
• Check to ensure that the power cable 5is inser-
ted into a power socket.
• Check to see if the light bulb 1of the table
lamp needs to be replaced. To do this, follow the
steps described in section 9. "Changing the light
bulb".
• Check to see if the power socket where the power
cord 5is plugged in is "live". To do this,
connect another electrical device to the power
socket.
• Check to see if the fuse or circuit breaker for the
electrical circuit to which the table lamp is con-
nected has been broken/triggered.
Other defects
Contact one of our service partners in your area if …
• the listed functional defects cannot be corrected
as described or
• other functional defects arise.
IB_KH4112_14_33345_LB6 10.06.2009 14:42 Uhr Seite 3

12. Disposal
Do not dispose of the appliance in your
normal domestic waste. This product is
subject to the European directive
2002/96/EC.
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Dispose of all packaging materials in an
environmentally friendly manner.
13. Warranty & Service
The warranty for this appliance is for 3 years from the
date of purchase. This appliance has been
manufactured with care and meticulously examined
before delivery. Please retain your receipt as proof of
purchase date. Should a claim need to be made un-
der the warranty, please make contact by telephone
with our service department. Only in this way can a
post-free despatch for your goods be assured.
The warranty covers ONLY claims for material and
maufacturing defects, not for wearing or consuma-
ble or for damage to fragile components. This pro-
duct is for private use only and is not intended for
commercial applications.
The warranty will become void in the event of abusi-
ve and improper handling, use of force and internal
tampering not carried or approved by our authori-
zed service branch. Your statutory rights are not
restricted in any way by this warranty.
DES Ltd
Units 14-15
Bilston Industrial Estate
Oxford Street
Bilston
WV14 7EG
Tel.: [phone]
Fax: [phone]
e-mail: suppor[email protected]
Kompernass Service Ireland
Tel: [phone] (0,082 EUR/Min.)
Standard call rates apply. Mobile operators may vary.
e-mail: suppor[email protected]
14. Importer
KOMPERNASS GMBH
BURGSTRASSE 21
44867 BOCHUM, GERMANY
www.kompernass.com
- 4 -
IB_KH4112_14_33345_LB6 10.06.2009 14:42 Uhr Seite 4