Konig Security SEC-ADW10 User manual

SEC-ADW10
DOOR/WINDOW ALARM
Description:
1. Siren
2. Magnetic Contact
3. Keypad
4. Battery LED indicator
5. Battery Compartment
Battery installation:
1. The battery compartment is accessed from
the rear of the alarm by removing the screw
from the bottom and lifting the back cover (see
figure B).
2. Insert 4x AA size batteries (not included)
according the polarity as shown in figure C.
3. When the last battery is
inserted the alarm will beep
very loud to indicate that the batteries are
installed properly. Replace the back cover.
NOTE: After removing the batteries, press
number 4 before installing new batteries. The
alarm must be programmed again with the
security code each time the batteries are
removed or replaced.
ENGLISH
INSTRUCTIONS

Alarm installation:
Alarm
Place the alarm on the door or
window with screws or adhesive tape.
Magnetic contact
The magnetic contact must be
aligned to the same level next to the
alarm so contact can be made when the door or window is closed,
either on the left or right side (see figure D).
NOTE: it’s recommended to program the alarm before installation.
Program alarm:
Immediately, after inserting the batteries, the 4 digit security code
must be set, simply press a desired 4 digit code on the keypad.
Operation:
Press, when leaving the protected area, digit 4 on the keypad. A
confirmation tone will indicate that the alarm is armed. You have 30
seconds to leave the area. After this time, if the contact is broken
the alarm will sound.
When entering the protected area, simply type your 4 digit security
code within 10 seconds. This will disarm the alarm.
Remark: if the LED indicator is constantly on, it means that the
batteries need to be replaced.
Warning:
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician if service is required. Do not
expose the product to water of moisture.
Warranty:
No guarantee or liability can be accepted for any changes and
modifications of the product or damage caused due to incorrect use
of this product.
General:
Designs and specifications are subject to change without notice.
www.konigsecurity.info