KornKraft Terra Luna User manual

Instruction manual – aTerra-Lun
You are the owner of the model Terra Luna, a high manual grain mill.
It was manufactured for you by artisanal craftmanship.
Before you start the milling, please note the following points:
Mounting
Push the handle into the hole inside of the stainless steel disc. Put
the flat nut (left hand thread) in the hexagonal slot inside of the
grinding stone. Push them together from below to the handle axis and
screw it by turning to the left until the end of the thread. Now put
the washer on the axis and screw the clamping screw on it by turning
to the right, until the handle turns easily.
Fixation of the mill
Fasten the mill on a work surface,
Sense of rotation
Turn the handle to the left ( this corresponds to the clockwise
rotation in vertical position) In the horizontal position the muscle
power is optimally used by turning it to the left.
Setting the fineness
The adjustment knob is situated under the housing.
Turn it by holding the handle.
- Turn it to the left for a coarse grinding
- Turn it to the right for a fine grinding
(please see the arrow on the knob)
To change the setting from coarse to the finest, it’s recommended to
turn the handle two times to the right, so you get an opening
between the mill stones.
Michael Gergen
Hüttenstraße 6
D-66839 Schmelz
Tel. [phone]
Fax. [phone] - 77 77 24
www.kornkraft.de
[email protected]
GETREIDEMÜHLEN

Running in
First you should run the mill in. Do this by milling approx. 30 grams (one tablespoon) of dry
grains (wheat, millet or barley are particularly suitable for this) at a medium setting. Turn
the handle anti-clockwise.
The first time you use the mill, abrasion of the millstone occurs which is perfectly harmless
to health but can contain stone particles. That’s why it is not suitable for consumption.
Warning
Please never turn the disc to tight, if the grinding stones grate one against the other, they
can smooth and the function is no more given.
Filling in
To fill in the grains, remove the cover of the opening. Push the cover on the left, so it lifts
up at the right. The filling works optimally with the storage container Moritz. Otherwise
you can also use a grain shovel.
Suitable grains
You can use the mill to grind all types of grain, no popcorn. To grind oil seeds, mix them
with dry grains. If you grind oat types with a gigh oil content at fine settings, the grinding
mechanism may clog (see cleaning and care)
Cleaning and care
Normally it is not necessary to clean the grinding mechanism. However, if it does become
clogged (e.g. with moist cereal or oil seeds), we recommend grinding a handful of rice at a
medium setting. Rice is very dry and brittle so it lifts off the sticky residues and cleans the
grinding mechanism.
Due to a surface treatment of beeswax balm the mill is protected from dirt.
You can clean the mill housing with a damp cloth; never apply water directly.
Do not keep the mill in an extremely dry place (above a source of heat) or an extremely
moist place (water vapour above a cooker). This could cause the wood to warp.
10 years from the date of purchase for defects attributable to material or
manufacturing defects.
To ensure your warranty, please keep your receipt!
Warranty
Made
in Germany
Warranty
10 years
Michael Gergen
Hüttenstrasse 6
D-66839 Schmelz
Phone [phone]
Fax. [phone]
G e t r e i d e m ü h l e n