Kozyard Bistro Bar Swivel Chair User manual

Bistro Bar Swivel Chair
Assembly Manual
• Prior to assembly, ensure that you lay out and identify all
the parts listed in the parts list.
• Tighten all nuts and bolts securely. Hand-tighten all bolts
before use. Avoid using power tools or applying excessive
force during assembly and bolt tightening.
• If you encounter any difficulties during assembly or if any
part is missing or damaged, please don't hesitate to
contact our customer service team via email at
[e-mail] or by calling our toll-free number at
866-355-0018.
• The weight capacity of this recline chair is 250 lbs.
• Clean the frame components and fabric with a mild soap
solution, then rinse thoroughly. Avoid using bleach, acid,
or any other solvents on either the fabric or frame compo-
nents.
• For a comprehensive warranty policy, please visit
www.kozyard.com. Be aware that warranty terms can
change without prior notification.
• For the best performance and safety of your chair, inspect
and tighten all bolts and fasteners regularly
Assembly Instructions
Care and warranty
Kozyard LLC Products
www.kozyard.com
© Copyright 2016 - 2023 Kozyard LLC. | All Rights Reserved.
Version:20231006

F
G
Part list
A
B
C
D
E
Description Qty
Part
112
8
4
33
4
33
28
4
1
1
1
1
4
1
1
1
Leg
Wheel
Leg Connector
Bolt
Bolt
M6*15
M6*32
Bolt
Bolt
Nut
Left Arm
Seat
Right Arm
Back
I
J
K
L
M
N
Q
S
T
P
Description Qty
Part
H4
M6*35
Washer
Allen Key
Screw Driver
Spring Washer
Cap
Cap

Swivel Chair
A
A
C
D
L
L
J
J
N
N
P
P
L
J
N
P
B
B
!Do not fully tighten all screws until
the final step.
1. Connect the Right Arm (Part A) and Left Arm (Part
B) to the Seat (Part C) using Bolt (J), Spring Washer
(N), Washer (L), and Cap (P) as shown in the diagram.
2. Connect the Back (Part D) to the Right Arm (Part A)
and Left Arm (Part B) using Bolt (J), Spring Washer (N),
Washer (L), and Cap (P), as shown in the diagram.

Swivel Chair
L
N
K
P
E
G
!Don’t fully tighten all screws
until Final step.
E
I
P
N
L
F
3. Attach Leg (Part E) and Leg Connector (Part G)
using Bolt (K), Spring Washer (N), Washer (L), and Cap
(P) as shown in the diagram.
4. Attach Leg (Part E) to Wheel (Part F) using
Bolt (I),Spring Washer (N),Washer (L), and
Cap(P) as shown in the diagram.

H
P
F
C
L
N
M
Q
E
G
5. Connect the finished base (Part E & F & G) to the
seat (Part C) using Bolt (H), Spring Washer (N),
Washer (L), Nut (M), and Caps (P & Q) as shown in the
diagram.
Eventually, Ensure that all bolts are securely tightened
before using the product on level ground.
866-355-0018
© Copyright 2016 - 2023 Kozyard LLC. | All Rights Reserved.
Kozyard LLC