Kramer VP-440 User manual

KRAMER
VP-440 Quick Start Guide
This guide helps you install and use your product for the first time. For more detailed information, g
http://www.kramerav.com/manual/VP-440 to download the latest manual or scan the QR code on the left.
o to
Step 1: Check what’s in the box
4 Rubber feet
1 Quick start guide
The VP-440 Presentation Switcher/Scaler
1 Power cord
Step 2: Install the VP-440
Mount the machine in a rack or place on a table.
Step 3: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your .
For best results, we recommend that you always use Kramer high-performance cables to connect AV equipment to the VP-440.
VP-440
P/N: Rev:
VP-440 Quick Start (P/N: 2900-300476QS REV 2)
For the Ethernet and HDBaseT connectors,
see the proper wiring diagram below:
1
2
3
4
5
6
7
8
Orange / White
Orange
Green / White
Blue
Blue / White
Green
Brown / White
Brown
PIN Wire Color
EIA / TIA 568B
RJ-45 Pinout
For optimum range and performance use
Kramer's
BC-HDKat6a cable. This specially built cable
significantly outperforms regular CAT 5/CAT 6
cables.
2 9 0 0 - 3 0 0 4 7 6 QS
2
For a condenser
microphone:
For a dynamic
microphone:
The Microphone Pinout:
Microphone +
Microphone -
Ground
Microphone
Ground
Microphone
BluRay Disk
Player Laptop
Analog Audio
Inputs
Analog Audio
Output
Projector
LCD
Display
Computer Graphics
Source (PC)
PC
Control Device

Step 6: Operate via the front panel buttons and/or via the:
Step 5: Set operation parameters via OSD menu
WWW.KRAMERAV.COM
RS-232 and Ethernet:Embedded Web
Page:
Connect the 5V DC power adapter to the rear of the VP-440 and connect the adapter to the mains electricity.
Step 4: Connect the power
Enter the OSD menu via the MENU button
on the front panel. Select a menu item
and set parameters as required.
If you cannot see any images, verify that the
display, TV, or projector is in good working
order and is connected to the VP-440. If you
still don't see an image, press and hold the
RESET TO XGA/720P button for 3 seconds
to reset the output to XGA or 720p
resolution.