Kramer VP-734 User manual

KRAMER
VP-734 Quick Start Guide
This guide helps you install and use your product for the first time. For more detailed information, g
http://www.kramerav.com/manual/VP-734 to download the latest manual or scan the QR code on the left.
o to
Step 1: Check what’s in the box
1 Power cord
1 Quick start guide
1 Set of ear racks
4 Rubber feet
The VP-734 Presentation Switcher/ Scaler
IR remote control transmitter with batteries
Step 2: Install the VP-734
To rack mount the machine attach both ear brackets to the machine (by removing the three screws
from each side of the machine and replacing those screws through the ear brackets) or place the
machine on a table.
Step 3: Connect inputs and outputs
Always switch OFF the power on each device before connecting it to your .
For best results, we recommend that you always use Kramer high-performance cables to connect AV equipment to the VP-734.
VP-734
BlueRay
Disk Player
Laptop Notebook
P/N: Rev:
VP-734 Quick Start (P/N: 2900-300357QS REV 2)
Step 4: Connect the power
Connect AC power to the rear of the VP-734, switch on its power
and then switch on the power on each device.
Connect the AUDIO LINE OUT stereo audio output
Balanced stereo audio
connection
Unbalanced stereo
audio connection
2
Analog Audio
Inputs
Active
Speakers
DVD Player
(CV via breakout cable)
Computer Graphics
Source (VGA) Projector Monitor Speakers Audio Power Amplifier
PC
Control Device
2 9 0 0 - 3 0 0 3 5 7 QS
All manuals and user guides at all-guides.com
all-guides.com

Step 6: Operate via the front panel buttons and via the:
Step 5: Set operation parameters via the OSD menu
IR Remote RS-232 and Ethernet Embedded Web Page
Enter the OSD menu via the MENU button on the front panel or the IR remote control
transmitter. Select a menu item and set parameters as required. Sub-menus include:
Input, Picture, Output, PIP, Audio, Setup and Info
WWW.KRAMERAV.COM
If you cannot see any images, verify that the display, TV, or projector is in good
working order, is connected to the VP-734, and that the VP-734 is selected as its
source. If you still don't see an image, press and hold the RESET TO XGA/720P
button for 5 seconds to reset the output to XGA or 720p resolution.
LR-16
POWER
UNIV 1
HDMI 4
HDMI 1
HDMI 3
DP
VOL
HDMI 2
UNIV 2
Freeze
Auto Image Save Recall
MENU
Reset Info
Blank
Mute
RS-232
Baud Rate: 115,200
Data Bits: 8
Stop Bits: 1
Parity: None
Command Format: ASCII
Example (switch input to UNIV2): Y 0 92 1<CR>
Ethernet
To reset the IP settings to the factory reset values go to : Menu->Setup -> Factory RESET->Change the
option to YES and press Enter
IP Address: 192.168.1.39
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.254
TCP Port #: 80
Maximum TCP Ports: 4
Full Factory Reset
OSD Go to : Menu-> FACTORY DEFAULT -> press Enter to Confirm
Front panel buttons Press the Button while plugging the power to reset the
Reset to XGA/720p
machine
All manuals and user guides at all-guides.com