KRESS KUF05.9 Installation manual

SAFETY AND OPERATING MANUAL
Lithium-Ion LED Worklight KUF05.9

3
Lithium-Ion LED Worklight KUF05.9
SAFETY POINTS FOR
YOUR FLASHLIGHT/
WORKLIGHT
SAFETY RULES FOR CORDLESS PORTABLE
HAND-HELD LIGHT
CHARGE BATTERY BEFORE FIRST USE
CAUTION: Read, understand and follow all
Safety Rules and Operating Instructions in this
Manual before using this product.
SAVE THESE INSTRUCTIONS!
READ ALL INSTRUCTIONS!
SAFETY INSTRUCTIONS
WARNING: Be sure to read and understand
all instructions in this manual before using
this portable hand-held light. Failure to follow all
instructions may result in electric shock, fire and/
or serious personal injury.
1.. Know your cordless portable hand-held light.
Read operator’s manual carefully.Learn its
applications and limitations, as well as the specic
potential hazards related to this light.
2.. Use only recommended battery pack and
charging stand / transformer.
Any attempt to use another battery pack will cause
damage to the portable hand-held light and could
possible explode, cause a re, or personal injury.
3. Remove battery pack from portable hand-
held light before performing any routine
maintenance or cleaning.
4. Do not disassemble the portable hand-held
light.
5. Do not place portable hand-held light or
battery pack near fire or heat. They may
explode. Also, do not dispose of a worn out
battery pack by incineration, even if it is
severely damaged or completely worn out.
The battery may explode in fire.
6. Do not operate portable hand-held light or
charging stand/transformer near flammable
liquids or in gaseous or explosive atmospheres.
Internal sparks may ignite fumes.
7. To reduce the risk of electric shock, do not
put portable hand-held light in water or other
liquid. Do not place or store portable hand-
held light where it can fall or be pulled into a
tub or sink.
8. Do not permit children to use portable hand-
held light unsupervised. It is not a toy. The
temperature of the bulb will become hot after
being on only a short period of time. This hot
temperature can cause burn injury if touched.
9. DO NOT USE OR PERMIT USE OF PORTABLE
HAND-HELD LIGHT IN BED OR SLEEPING
BAGS. This portable hand-held light lens can
melt fabric and a burn injury could result.
10. Keep light dry, clean, and free from oil and
grease. Always use a clean cloth when
cleaning. Never use brake fluid, gasoline,
petroleum-base products or any strong solvent
to clean the portable hand-held light.
11. The light source of this luminaire is not
replaceable; when the light source reaches
its end of life the whole luminaire shall be
replaced.
SAFETY WARNINGS FOR
BATTERY PACK
a) Do not dismantle, open or shred cells or
battery pack.
b) Do not short-circuit a battery pack. Do not
store battery packs haphazardly in a box or
drawer where they may short-circuit each
other or be short-circuited by conductive
materials. When battery pack is not in use, keep
it away from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal
objects, that can make a connection from one
terminal to another. Shorting the battery terminals
together may cause burns or a re.
c) Do not expose battery pack to heat or fire.
Avoid storage in direct sunlight.
d) Do not subject battery pack to mechanical
shock.
e) In the event of battery leaking, do not
allow the liquid to come into contact
with the skin or eyes. If contact has been
made, wash the affected area with copious
amounts of water and seek medical advice.
f) Keep battery pack clean and dry.
g) Wipe the battery pack terminals with a
clean dry cloth if they become dirty.
h) Battery pack needs to be charged before
use. Always refer to this instruction and
use the correct charging procedure.
i) Do not maintain battery pack on charge
when not in use.
j) After extended periods of storage, it may
be necessary to charge and discharge
the battery pack several times to obtain
maximum performance.
k) Recharge only with the charger specified
by Kress.Do not use any charger other
than that specifically provided for use with
the equipment.
l) Do not use any battery pack which is not
designed for use with the equipment.

4
Lithium-Ion LED Worklight KUF05.9
m) Keep battery pack out of the reach of
children.
n) Retain the original product literature for
future reference.
o) Remove the battery from the equipment
when not in use.
p) Dispose of properly.
q) Do not mix cells of different manufacture,
capacity, size or type within a device.
r) Keep the battery away from microwaves
and high pressure.
SYMBOL
To reduce the risk of injury, user must
read instruction manual.
Batteries may enter water cycle if
disposed improperly, which can be
hazardous for ecosystem. Do not
dispose of waste batteries as unsorted
municipal waste.
Do not burn
Li-I on
Li-I on
Li-Ion battery. This product has been
marked with a symbol relating to
‘separate collection’ for all battery
packs and battery pack. It will then
be recycled or dismantled in order to
reduce the impact on the environment.
Battery packs can be hazardous
for the environment and for human
health since they contain hazardous
substances.
Class III
Replace any cracked protective
shield
Do not stare at the operating light
source
The box is recyclable at the kerbside.
RCM marking
ABN: Australian Business Number. By this number,
business information such as entity type, status,
business location etc. can be found at website http://
abr.business.gov.au. ABN of Positec Australia Pty
Limited is 14 101 682 357

5
Lithium-Ion LED Worklight KUF05.9
1
2
3
4
5
6
7
8
9

6
Lithium-Ion LED Worklight KUF05.9
B
C
E
D
A
G

7
Lithium-Ion LED Worklight KUF05.9
COMPONENT LIST
1. HANDLE SLEEVE
2. HANDLE
3. ADJUSTING KNOB
4. HOOK
5. BRACKET SEAT
6. RUBBER PAD
7. BRACKET
8. FRONT COVER
9. ON / OFF SWITCH
Not all the accessories illustrated or described
are included in standard delivery.
TECHNICAL DATA
KUF05.9
Rated Voltage 20V Max*
Lumen I: 750LM; II: 1500LM
Machine weight 2.0kg
*Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Action Figure
OPERATION
Starting & Stopping
To start your light just depress on/off
switch marked “I”.
To stop your light just depress the on/off
switch marked “O”.
Warning!
Do not direct the light beam into
your eyes.
See Fig. A
Placing the light
Warning! Ensure the work light is
securely placed to prevent falling
object hazard.
Using the hook to hang the light
Warning! Do not hang the work
light on any electrical power cord!
See Fig. B
Using the bracket to set the light
Add: You may use a screw to secure
the work light in place.
See Fig. C
Using the bracket to hang the light See Fig. D
Adjustable head
The work light head can be set in a
variety of positions. To switch base
positions, rotate the adjusting knob to
loosen the light. Adjust head to desired
position , tighten the adjusting knob .
Caution!
Do not place hands or ngers between
adjustable head and bracket when
positioning work light to avoid any
hazard!
See Fig. E
MAINTENANCE
Your tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your
tool. Never use water or chemical cleaners to clean your
tool. Wipe clean with a dry cloth. Always store your tool
in a dry place.
ENVIRONMENTAL
PROTECTION
Disposal
The machine, its accessories and
packaging materials should be sorted
for environmentally friendly recycling.
The plastic components are labeled for categorized
recycling.
Positec Australia Pty Limited
10 Corporate Blvd Bayswater, VIC 3153, Australia

Copyright © 2022, Positec. All Rights Reserved.
AR01651800