Kriega OS-32 User manual

PANNIER FRAMES
To fit the Kriega OS-32 the bike MUST have pannier frames fitted. These are model specific, available
as accessories from bike manufacturers or other after market suppliers. including: Touratech,
SW-Motech, Rallyraid Products, Shift Manufacturing, Metal Mule.
OS-32 SOFT PANNIER FITTING INSTRUCTIONS
There are 2 options to fit the OS-32 pannier bags to the bike:
1. Traditional ‘over the seat’ saddlebag
format, using OS-STRAPS*
RALLYRAID PRODUCTS - KTM 690 SW-MOTECH - HONDA AFRICA TWIN SHIFT MANUFACTURING - HUSQVARNA 701
(OS-STRAPS FITTING ONLY)
2. Fixing an OS-PLATFORM* to the frame
and mounting the OS-32 to the
platform.
*Sold separately

OS-STRAPS (sold separately)
Attach the OS-STRAPS to the rear buckle loops on each OS-32 as follows:
Adjust strap length to suit bike width.
IMPORTANT
Once the bags are mounted across the seat, the OS-32
straps must wrap around the bottom rail of the pannier
frame to hold it firmly in position. (see back page)

PLATFORM FITTING
A. Standard hoop pannier frames with 18mm or 3/4” tubes
Fitting hardware is supplied with each OS-PLATFORM, attach to the hoop frame as illustrated below.
NOTE: The rear clamps may need rotating 180° to suit your frame, one recess is 18mm the other 3/4”
in diameter. The OS-PLATFORM is designed with various clamp mounting holes. The mounting
position illustrated below is a guide, you may need to use the alternative mounting holes depending
on your frame design.
B. SW-Motech® Evo Carrier
Fitting hardware is supplied with each OS-PLATFORM, attach to the Evo Carrier as illustrated below.
OS-PLATFORM (sold separately)
Available with 2 fitting options to suit either :
The standard hoop pannier frames with 18mm or 3/4” tubes A. or SW-Motech® Evo Carrier B.
NOTE
Use a semi-permanent thread-lock on all fastenings.

1. Pass the top straps and alloy buckles through the slots on the OS-PLATFORM, this will hold the
bag in position, then pass the bottom straps through the slots at the base of the OS-PLATFORM.
2. Attach the top and bottom strap hooks.
3. Pull the strap upwards to remove any slack from underneath the bag.
Then pull the strap through the cam buckle to fully tighten.
Finally lock-o the web by pushing the cam on the buckle down.
4. Push the remaining strap down inside the front of the pack.
FITTING OS-32 TO THE OS-PLATFORM
CARE INSTRUCTIONS
The white liner can be easily removed for cleaning.
Both the liner and the main pack can be hand washed in warm
water with mild soap.
CAUTION: detergents will damage the waterproof fabric coatings.
DO NOT tumble-dry or place on direct sources of heat.
It is the owner’s responsibility to ensure the pannier bags are attached in such a way that it does not damage or put at risk the owner or the property
of the owner. Do not exceed the UK legal speed limit. This product has only been tested for up to UK road legal speeds.
1. 2.
3. 4.