2
To install your Djangobucker
simply follow these steps:
Take two small lentil sized pieces of the
included putty, and apply to each side of the
pickup as Shown. Flatten the putty as much
as you can to avoid adding any unnecessary
height to the pickup. It only takes a tiny
amount of putty to securely adhere the
pickup to the guitar. →
Place your pickup on the guitar such that the
magnetic pole-pieces are aligned under each
string Gently, but firmly, press the pickup
down using a slight rocking motion until it is
securely affixed to the guitar. →
Balancing your New Pickup
Your Djangobucker should be well
balanced right out of the package.
However, bringing a pole closer to the
strings (i.e., loosening it) will increase
the
volume of that string; bringing the pole
farther
from the strings (i.e., tightening it)
will decrease
the volume of the string. For
best results adjust the other strings as
needed to match the volume of the “b”
string which is typically the loudest string.