KSE-LIGHTS KS-9800 User manual

Wichtig: Vor Bedienung bitte Gebrauchsanweisung lesen !
Beschreibung:
KS-9800 ist eine Handlampe für den Gebrauch in potentiell
explosionsgefährdeten Bereichen. Betrieben wird die Lampe von
drei C Alkaline-Zellen. Sie hat zwei Schaltstufen für Stark- und
Normallicht.
Installation:
Batterien:
Benutzen Sie nur folgende ALKALINE Batterien: Gebrauch:
Zum Einschalten betätigen Sie den Druckknopf am hinteren
Lampengehäuse. Einmaliges Schalten ( Starklicht ),
zweimaliges Schalten ( Normallicht ), dreimaliges Schalten (
Lampe erlischt.
Typ: ENERGIZER
E93
DURACELL
MN1400
RAYOVAC 814
VARTA 04914
Zertifizierungen:
UL USA : UL FILE NO.: OERX.E324236
Class I Div 1 & 2 Grp ABCD
Class II Div 1 & 2 Grp EFG
Class III Temp Code: T4
IECEx Worldwide : IECEx CERTIFICATE NO.:
IECEx UL 13.0008X
Ex ia IIC T4 Ga
Gebrauch der Batterien:
Lampe nicht in explosionsgefährdeten Bereichen öffnen.
Um jegliches Explosionsrisiko auszuschließen, verwenden Sie nie
gleichzeitig gebrauchte und neue Batterien oder Batterien unterschiedlicher
Hersteller. Laden Sie diese Batterien entsprechend der Anweisung des
Herstellers.
Entfernen Sie die Batterien, falls Sie die Lampe längere Zeit nicht
gebrauchen.
Ex Europe : ATEX CERTIFICATE NO.:
DEMKO 13 ATEX 1112940X
II 1G Ex ia IIC T4
0539
Standards:
UL913, 7th edition
CAN/CSA C22. No.157-92
EN60079-26 : 2007
EN60079-0 : 2009
EN60079-11 : 2007
IEC60079-26 : 2006
IEC60079-0 : 2007
IEC60079-11 : 2006
1.
2.
3.
4.
5.
6.
7.
8.
Sicherheitswarnung:
1. Die Schraube zum Sichern des Lampenkopfes sollte jederzeit
fest angezogen sein.
2. Niemals direkt in die Augen leuchten.
Gebrauchsanweisung Handlampe KS-9800
für Verwendung in explosionsgefährdeten Bereichen
Eigenschaften:
- High power Cree LED
- IP 67
- Stark- und Normallicht
- schlag- und stoßgeschütztes Gehäuse
KSE-LIGHTS GmbH
Brunnenstrasse 8, 58285 Gevelsberg
Germany
Serviceformular
Kundenname:
________________________________________________
Kaufdatum:
________________________________________________
Fehlerbeschreibung :
________________________________________________
Technische Daten :
Starklicht Normallicht
Lichtstrom
Leuchtdauer
Reichweite
Fallresistenz
Impressionsschutz
Abmessungen
Gewicht
125 lm 80 lm
40 h 60 h
185 m 144 m
1 m
IP 67
225 60 85 mm
190 g

Important:
READ THESE INSTRUCTIONS BEFORE USE AND MAINTAIN
THE FLASHLIGHT FOR REFERENCE.
Instruction:
Thank you for choosing KS-9800 as your best selection with
the highest standards and certifications approved.
Installation:
Product:
KS-9800 Industrial Flashlight
For Use in Hazardous Locations
Battery:
3 x C ALKALINE batteries
On and off button:
Lighting by pressing on/off rubber button on the end of KS-
9800 by turning it on, and turn it off as well.
Batteries
type:
ENERGIZER
E93
DURACELL
MN1400
RAYOVAC 814
VARTA 04914
Operation:
Certifications:
UL USA : UL FILE NO.: OERX.E324236
Class I Div 1 & 2 Grp ABCD
Class II Div 1 & 2 Grp EFG
Class III Temp Code: T4
IECEx Worldwide : IECEx CERTIFICATE NO.:
IECEx UL 13.0008X
Ex ia IIC T4 Ga
Change of batteries:
Warning – Replace batteries only in non hazardous areas.
Please unscrew the front cap, please do not directly touch
inside heat sink set, it might be a bit hot after long time using,
remove the cap, remove the reflector with LED inserted,
avoiding touching inside surface of reflector, it might affect the
performance of lighting. Always using proper batteries to go
with KS-9800, do not mixed brand using. Always replace all
batteries at the same time, filling new batteries in
corresponding to (+) positive and (-) negative mark sticker
inside of battery case by three rules to batteries:
Ex Europe : ATEX CERTIFICATE NO.:
DEMKO 13 ATEX 1112940X
II 1G Ex ia IIC T4
0539
a
.
Use only battery type of Energizer E93 or Duracell
MN1400 or Rayovac 814 or Varta 04914.
Do not mix used batteries with new batteries.
Do not mix batteries from different manufacturers.
b
Filling 3 pieces C type batteries with positive (+) pole
identically Upward direction, when re-insert reflector set, with
smart design, please gently insert it, it could slowly slide into
groove and fit it well, please do not over-force on it. Closing the
flashlight by screwing the cap right to end of the screw thread.
And with long period of time without using the flashlight,
batteries should be removed out for avoiding battery leaking
which may cause damage to flashlight’s life.
Standards:
UL913, 7th edition
CAN/CSA C22. No.157-92
EN60079-26 : 2007
EN60079-0 : 2009
EN60079-11 : 2007
IEC60079-26 : 2006
IEC60079-0 : 2007
IEC60079-11 : 2006
1.
2.
3.
4.
5.
6.
7.
8.
WARNING: The screw should be secured tightly after
replacing of batteries.
Safety warning:
Do not flash the light beam directly to human’s eyes, it may
cause temporarily dizzy, please leave away, and close your
eyes immediately when light beam moves toward to your
eyes directly. Batteries replacement can be only
performed when in non-hazardous location. Always use this
flashlight by following regular and legal rules governed by
industrial control and management authority from every
country.
User manual for model KS-9800
FLASHLIGHT FOR USE IN HAZARDOUS LOCATIONS
Features:
-High intensity Cree LED
-Two ways position Clip
-The clamp fixed on
-conspicuous location
-On / Off Button
-Water Proof
KSE-LIGHTS GmbH
Brunnenstrasse 8, 58285 Gevelsberg
Germany
Complaint data sheet
Customer:
________________________________________________
Date of purchase:
________________________________________________
Description of trip :
________________________________________________