KUS HSD User manual
User’s Manual
HSD Sensor
www.kus-usa.com
Revision History
Description
Original Document
Revision
1.0
www.kus-usa.com
Table of Contents
1
1
1. Installation Tool and Preparation
2. Installation Steps
.......................................................................................
...............................................................................................................
1
www.kus-usa.com
Figure. 1
Applicable to tank without flange assembly
2. Empty tank, clean tank with water, keep filler open.
Step 1:
Place gasket where you would want hole to be
drilled in tank and keep it centered (notching
direction of gasket is the direction of the outlet);
draw the 1 big hole and 5 small holes by pencil
(Figure 1).
Preparation: 1. Tool: 4.0mm/
18" drill, 40~45 mm/1
12" opener, marker pen, electric hand drill.
2. Installation Steps
1. Installation Tool and Preparation
2
www.kus-usa.com
Figure. 2
4.0~4.2 / mm
40.0mm/11"
8
Figure. 3
1"
2
1
1
Step 2:
Align the area, then drill hole with opener (Figure. 2).
Step 3:
Drill 5 holes separately with ∮4.0~4.2mm/ drill (Figure.3).
Note: Cover big hole and remove chips in small hole to avoid them falling in tank.
8
3
www.kus-usa.com
Figure. 4
Step 4:
Assemble gasket and sensor into tank, screw and fix sensor in star pattern (see Figure. 4).
Diagram of Star Pattern
Table of contents
