Kusam-meco 286 SVD User manual

G-17, Bharat Industrial Estate, T. J. Road, Sewree (W), Mumbai - 400 015. INDIA.
Sales Direct.: 022 -24156638, Tel. : [phone], Fax : 022 - 24149659
Email : [email protected], Website : www.kusamelectrical.com
An ISO 9001:2008 Company
®
All Specifications are subject to change without prior notice
Navin.com/D.drive/sandeep gupta/New catlog Dec 2011/286SVD.cdr
An ISO 9001:2008 Company
®PERSONAL SAFETY H. V. DETECTOR
Model 286 SVD
SPECIAL FEATURES :
?Compact, easy to wear and convenient in use.
?Usable both indoor and outdoor.
?Water-proof design.
?Equipped with self-testing functions.
?Sound and flash light warning of different frequencies varied positively with sensed voltages.
?Able to sense all kinds ofAC High Voltage System.
?Low power consumption.
?CE Certified.
GENERAL SPECIFICATIONS :
íDistance of starting warning : 80cm for 11.4KV (6.6KV voltage to earth)
íMin. Sensing Voltage : 1.1KV
íApplicable Frequency : 50/60Hz
íVolume : 70dB or higher at 1 meter distance
íOperating Temperature & Humidity : 5°C ~ 45°C / 80% R.H.
íBattery life : 50 hours for continuous use.
íBattery : CR2032
íOutside dimensions : 59(L) x 56(W) x 18(H) mm
íWeight : Approx. 35g.(including Battery)
ACCESSORIES :
Elastic cord, Band, Bracket, Instruction manual & Battery.
METHOD OF USE
?Inspection before use
(1) Check the appearance and structure for any abnormality.
(2) Press Self-Test switch (about 10 seconds) to confirm all functions are working
normally.
(3) To be careful and to avoid misjudgement, test the unit by contacting AC 110V /
230V insulated wire with its front side to see if it sounds and flashes.
?Wearing
Wear the unit to the outer side of fore arm with the sensing side faces outwardly,
as shown in the figure :
The effect is best when the sensing side is facing high voltage in right angle (90Deg.).
When it is worn at the inner side of arm or is covered by cloth, the sensitivity is
poorer.
286 SVD is a sensor for sensing AC High Voltage for personal safety. It provides electric engineering
personnel, power engineering personnel, firefighting personnel and instrument equipment workers with
prominent warning when approaching high voltage and for taking necessary safety action, preventing
illusion and misjudgment which could lead to electric shock to an individual.
When a person wearing 286 SVD is approaching high voltage source or equipment, the sensor will
detect automatically and buzzer will generate a “Bi-Bi” short sound for warning and LED will give flash
light to remind operators that the user is approaching a high voltage and special attention shall be given
to the safety of operations.

®
PERSONAL SAFETY
H.V. DETECTOR
MODEL - 286 SVD
OPERATION
MANUAL
G 17,Bharat Industrial Estate, T. J. Road,
Sewree (W), Mumbai - 400 015. INDIA.
Sales Direct : [phone]
Tel. : [phone]. Fax : [phone]
Email : [email protected]
Website : www.kusamelectrical.com
www.kusam-meco.co.in
®

01
PERSONAL SAFETY
H.V. DETECTOR
MODEL - 286 SVD
286 SVD is a sensor for sensing AC High Voltage.
It provides electric engineering personnel, power
engineering personnel, firefighting personnel and
instrument equipment workers with prominent
warning when approaching high voltage and for
taking necessary safety action, preventing
illusion and misjudgment which could lead to
electric shock to person.
INTRODUCTION
When a person wearing 286 SVD is approaching
high voltage source or equipment, the sensor will
detect automatically and buzzer will generate a
beep sound for warning and LED will flash to
remind operators that the user is approaching a
high voltage source and special attention shall be
given to the safety of operations.

02 03
?Compact, easy to wear and convenient in use.
?Usable both indoor and outdoor.
?Water-proof design.
?Equipped with self-testing functions.
?Sound and flash light warning on different
frequencies varied positively with sensed
voltages.
?Able to sense all kinds of AC High Voltage
System.
?Low power consumption.
?Meets : EN61326-1
FEATURES :
?Distance of starting warning : 80cm for 11.4kV
(6.6kV to earth)
?Applicable frequency : 50 / 60Hz
?Volume : > 65dB at 1 meter distance
?Operating Temp & Humidity : 5°C - 45°C
80% R.H. Max.
?Outside Dimensions : 59(L) x 56(W) x 18(H)mm
?Weight : 35g. (Including battery)
?Battery to use : CR2032 x 1
?Battery life : Approx. 50 hours for continuous use
?Accessories : Elastic cord, Band, Bracket,
Instruction Manual & Battery.
SPECIFICATION
1. Inspection before use
METHOD OF USE
(1) Check the appearance and structure for any
abnormality.
(2) Press Self-Test switch (about 10 seconds) to
confirm all functions are working normally.
(3) To be careful and to avoid misjudgment, test
the unit by contacting AC 110V insulated wire
with its front side to see if it sounds and
flashes.
2. Wearing
Wear the unit to the outer side of fore arm with
the sensing side facing outwardly, or attach it to
hard hat, chest pocket forward, as shown in the
following figure :

04 05
The effect is best when the sensing side is facing
high voltage is right angle (90 Deg.). When it is
worn at the inner side of arm or is covered by cloth,
the sensitivity is poor.
3. Combination for attachment to chest pocket
CLEANING & REPLACING BATTERY
1. Sensing side should be kept clean. The case may
be cleaned with soft fabric and mild detergent.
No solvent or corrosive agent may be used.
2. Replacing Battery
(1) When the sound becomes weak, the battery
shall be replaced.
(2) Use coin to open battery cover and remove
used battery. Place new battery into slot with
the battery positive (+) face up and fasten
battery cover with coin.
CAUTIONS
1. This instrument is an auxiliary testing unit and is
only for obtaining warnings as additional protection.
Never use this instrument as substitution for
Tester. Electrical Test shall be the prime electric
testing instrument.
2. Other than affected by how you wear, the sensing
and warning distance may be influenced by
direction of electric article, ambient environment,
shielding objects and weather conditions.
3. Buzzer has inner water-proof film. Do not pierce
it with sharp article.
4. Do not store this instrument outdoor or inside of
car for long time to avoid direct sunbeam and
high temperature.
5. The instrument shall not be dropped or impacted
heavily. If such situation does happen, perform
inspection and self-test to ensure no damage
occurred before using again.
6. If the instrument is rinsed by rain, remove battery
and place it at cool place for natural dry.

06 07
MUMBAI
TEST CERTIFICATE
PERSONAL SAFETY
H.V. DETECTOR
This Test Certificate warrantees that the product
has been inspected and tested in accordance with
the published specifications.
The instrument has been calibrated by using
equipment which has already been calibrated to
standards traceable to national standards.
MODEL NO. __________
286SVD
SERIAL NO. ___________
DATE: ___________
ISO 9001
REGISTERED
QC
PASS
KUSAM-MECO
WARRANTY
Each “KUSAM-MECO” product is
warranted to be free from defects in
material and workmanship under normal
use & service. The warranty period is one
year (12 months) and begins from the date
of despatch of goods. In case any defect
occurs in functioning of the instrument,
under proper use, within the warranty
period, the same will be rectified by us free
of charges, provided the to and fro freight
charges are borne by you.
This warranty extends only to the original
buyer or end-user customer of a “KUSAM-
MECO” authorized dealer.
This warranty does not apply for damaged
Ic’s, fuses, burnt PCB's, disposable
batteries, carrying case, test leads, or to
any product which in “KUSAM-MECO’s”
opinion, has been misused, altered,
neglected, contaminated or damaged by
accident or abnormal conditions of
operation or handling.
“KUSAM-MECO” authorized dealer shall
extend this warranty on new and unused
products to end-user customers only but
have no authority to extend a greater or
different warranty on behalf of “KUSAM-
MECO”.

08 09
“KUSAM-MECO’s” warranty obligation is
limited, at option, free of charge repair, or
replacement of a defective product which is
returned to a “KUSAM-MECO” authorized
service center within the warranty period.
THIS WARRANTY IS BUYER’S SOLEAND
EXCLUSIVE REMEDY AND IS IN LIEU OF
ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING BUT NOT
LIMITED TO ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS
FOR A PA RTI C U LA R PURPO S E .
“KUSAM-MECO” SHALL NOT BE LIABLE
F O R A N Y S P E C I A L , I N D I R E C T,
INCIDENTAL OR CONSEQUENTIAL
DAMAGES OR LOSSES, INCLUDING
LOSS OF DATA, ARISING FROM ANY
CAUSE WHATSOEVER.
All transaction are subject to Mumbai
Jurisdiction.
G 17,Bharat Industrial Estate, T. J. Road,
Sewree (W), Mumbai - 400 015. INDIA.
Sales Direct : [phone]
Tel. : [phone]. Fax : [phone]
Email : [email protected]
Website : www.kusamelectrical.com
www.kusam-meco.co.in
®