Kutai electronics EB-9V User manual

EB-9V
Battery-powered Automatic Flashing Module
User Manual
Auto Flashing Unit

___________________________________________________________________________________________
2EB-9V
SECTION 1 : FEATURES
No external battery or DC power supply required, excitation power provided by an internal battery.
Small size, light weight, easy installation, saving labor.
Automatic excitation detection requires no manual operation or settings.
Very low static power consumption, Up to 3 years between battery replacement in standby mode.
Excitation function repeats 3 times and stops automatically when voltage is established.
Battery low voltage alarm reminds user to change battery.
Excitation failure warning, Resets automatically with voltage buildup or when engine stopped.
Battery reverse polarity protection.
Excitation field F+, F- Reverse Polarity Protection.
Manual Forced Excitation Function.
SECTION 2 : SPECIFICATION
AC Voltage Input
Lithium Battery Specifications
Voltage 1 300 Vac single-phase
Model no. Ultralife U9VL-J-P
Frequency 50/60 Hz
Voltage 9 Vdc
Current Normal discharge 700 mA Max
Excitation Output
Pulse discharge 1050 mA Max
Voltage 9 Vdc
Capacity 1200 mAh @ 23 ˚C
Power 700 mA Max.
Service Life 10 years
Automatic Flashing Detection
Environment
Automatically Outputs Excitation Power When Voltage
Operating Temperature -20 to +60 ˚C
< 10 Vac and Frequency > 40 Hz
Storage Temperature -40 to +60 ˚C
Relative Humidity Max. 95%
Excitation Time
Vibration 5 Gs @ 60 Hz
Excitation output 5 seconds, up to three attempts at
5 second intervals
Dimensions
87.0 (L) x 41.5 (W) x 61.7 (H) mm
Time Between Battery Change
3 years Max.
Weight
( Use only Ultralife U9VL-J-P lithium battery )
85 g +/- 2%
ATTENTION
1. Before using a Megger or a Withstand Voltage Tester, removes the wires connecting to the EB-9V to
prevent high voltage damage to the automatic flashing module.
2. Only the original factory ULTRALIFE U9VL-J-P lithium battery should be used for replacement.
3. Use of a standard alkaline battery will reducing the time the unit can operate and the service life of the
battery, could also cause voltage build-up function to fail.

___________________________________________________________________________________________
EB-9V 3
SECTION 3 : Explanation of Terminals, Indicators, and Adjustments
SECTION 4 : Dimensions / Connection Diagram
Unit : mm [inch]
41.5 [1.63"]
77.0 [3.03"]
61.7 [2.43"]
43.0 [1.69"]
87.0 [3.43"]
4.5 [0.18"]
Field
S
R
T
N
~
G
A C
1-300V
F +
F
Power
Low DC
Manual
External Dimensions
Connection Diagram
※Appearance and specifications of products are subject to change for improvement without prior notice.
A C
1-300V
F +
F
Power
Low DC
Manual
Manual：Manual Forced Excitation Button
Pressing this button forces excitation output
Low DC：Battery Voltage Low (red)
Flashes every 5 sec when battery voltage low
Both indicators will flash when excitation fails
Power：Power indicator (green)
Flashes every 5 sec in standby mode
Illuminates continuously during excitation output
F+、F-：Excitation Output
Connects to generator excitation field
AC Voltage input：1 300 Vac
Mounting Holes * 2