KYMCO LIKE 200I 2019 Installation instructions

KICK-START YOUR MOST CONSUMING OBSESSION
Recall Code # Like200-2019-Recall-Adj
NHTSA #19V036
LIKE 200I FUEL LINE FITTING INSPECTION/ REPAIR PROCEDURE
Tools needed: Phillips head screw driver, 10mm
socket w/ ratchet, a torque wrench with a usable
range of 0-30 lbf.in w/ 7mm socket, and a 6”
scale.
Step: 1
Open the seat compartment using the key.
Step: 2
Move contents to locate the 4 bolts and 2 screws
securing the seat/storage box and remove them.
Remove the seat/storage box as one unit and
place it to the side.
Step: 3
Locate the fuel line connection at the fuel pump
and fuel injector as indicated.
Step: 4

KICK-START YOUR MOST CONSUMING OBSESSION
Recall Code # Like200-2019-Recall-Kit
NHTSA #19V036
LIKE 200I FUEL LINE FITTING INSPECTION/ REPAIR PROCEDURE
Loosen the clamp and check the position of the
fuel line. Tighten the clamp to 18-23 lbf-in. with
a 0-30 lbf-in torque wrench and 7mm socket.
Step: 5
Loosen the clamp and check the position of the
fuel line. Tighten the clamp to 18-23 lbf-in. with
a 0-30 lbf-in torque wrench and 7mm socket.
When torquing the fuel line clamp at the fuel
injector, make sure to firmly support the fuel
injector at the fuel line clamp with your hand.
Step: 6
Check the length of the exposed tail of the
clamp for approximately 9/16” with a 6” scale to
confirm. If the exposed length is less than 9/16”,
re-torque until the exposed tail end has 7 steps
showing.
Step: 7
Turn on the main switch, start the engine and let the unit idle for 2 minutes. Open the
throttle slightly, checking for leaks. If no leak is present after 5 minutes, proceed to step 9.
Step: 8
Re-assemble the unit.
Step: 9
Testing the fuel line repairs:
Tighten the clamp at the fuel injector:
Tighten the clamp at the fuel pump: