Kyocera Mita FS-C5016N User manual

Packing Cover
Packing
Item
Magenta (M)
Cyan (C)
Yellow (Y)
Black (K)
Lock Lever
Cap
USB Interface
Parallel
Interface Network Interface
(Ethernet)
Power Cord
Connecter
FS-C5016N
Important!
Kyocera Mita assumes no liability for any damage caused by an improper
installation of the printer.
Installation Guide
Unpacking Checking Parts and Components
Installing the Toner Containers and Waste Toner Box
Close the paper transfer unit
tightly.
Unpack the printer. Remove the packing
cover.
Open the top cover and remove
the packing item.
In this example, it is assumed that you
are installing the black toner container.
Shake the new toner container
5 or 6 times as shown in the
figure in order to distribute the
toner evenly inside the
container.
Set the new toner container in
the printer as shown in the
figure below.
Note
Be sure you set the toner
container in the correct location
for that color.
Push down on the top of the
toner container to install it firmly
in place.
To install the other color toner containers,
use the same procedure above.
Close the top cover.
Open the left cover. Open the cap of the waste
toner box.
Insert the waste toner box as
shown in the figure. When the
box is set correctly, it will shap
into place.
Make sure that the waste toner
box is correctly inserted and
close the left cover.
For more information about the printer, refer to the Operation Guide (PDF) in the CD-ROM supplied with the printer.
2003 by KYOCERA MITA CORPORATION All rights reserved. 2-28, 1-Chome, Tamatsukuri, Chuo-ku, Osaka 540-8585, Japan
Printed in Japan 7KKTA80E++AX 2003.3
1 Printer
2 Documents and Software
• Installation Guide
(This sheet)
• Quick Reference Guide
• Quick Configuration
Guide (for Network)
• CD-ROMs
3 Magenta Toner Container
4 Cyan Toner Container
5 Yellow Toner Container
6 Black Toner Container
7 Waste Toner Boxes
(One is spare.)
8 Power Cord
Connect to the computer. Connect the power cord to the
power outlet.
Turn on ( | ) the printer power
switch.
8
1
2
5643
7
Be sure to hold
the right and left
sides of the
printer when
carrying it, as
shown in the
illustration.
Rear
Push the blue lock lever on the
toner container back towards
the locked symbol ( ) as far as
it will go.
Making Connections
1 2 3
4
567
8 9 10
11 12 13 14
15 16 17