KYOWA KW-6810 User manual

KYOWA SERVICE CENTER
Rm. 1203 State Center Building
#333 Juan Luna St., Binondo
Manila, Philippines
WALL FAN
MODEL # KW-6810
Voltage: 230V a.c. 60Hz Power: 55 WATTS
INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS
When using Kyowa Wall Fan, basic safety precautions should always be
followed:
Always operate your KYOWA Wall Fan from a power source of the same
voltage and frequency rating as indicated on the rating label.
Do not operate or place any part of your Wall Fan on or near any hot
surface such as a gas or electric burner, hotplate or heated oven.
Do not operate the Wall Fan if any part of it has been damaged. Return
the appliance to the nearest authorized dealer or service facility for repair.
Do not use or replace accessories of the Wall Fan, other than the ones
originally provided.
Switch OFF and unplug the Wall Fan from outlet when not in use or
before cleaning.
Always turn setting controls to OFF before disconnecting the cord from
the power supply. Hold plug when unplugging from socket. Do not unplug
by pulling the supply cord.
To reduce the risk of electric shock, do not immerse or expose the Wall
Fan to rain, moisture or any liquid.
Keep out of reach from children or from persons with mental or physical
disabilities.
CONGRATULATIONS
You are now a proud new owner of a KYOWA Wall Fan model no.
KW-6810.
Before using for the first time, kindly take time to carefully read your
instruction manual. Please observe all safety precautions and follow
operating procedures. After reading, kindly store your instruction manual in
a safe place for your future reference. Should you pass on this Wall Fan to
a third party, please hand over this instruction manual as well.
PARTS DESCRIPTION
1
2

HOW TO USE
HOW TO ASSEMBLE
Mount Rear Guard into the Motor by aligning Rear Guard holes into the
round pins on the motor. Push in gently until the Motor pins protrude
through the Rear Guard holes.
Secure Rear Guard in place by turning in Rear Guard Lock Nut into the
Shaft Guard. Rotate Rear Guard Lock Nut clockwise to lock in place.
Push Fan Blade into the Shaft.
Secure Blade by rotating Blade Cap into the Shaft counter-clockwise.
Fasten Front Guard into the Rear Guard. Connect Front and Rear Guard
by putting Guard Lock on the circumference of the attached Front and
Rear Guards. Tighten Guard Lock screw to lock in place.
OPERATING INSTRUCTIONS
Plug in Wall Fan into the power supply.
Pull string for Speed Control from 1 to 3 speed setting. Pull string to 0 to
turn the unit to OFF.
From steady mode, pull Oscillating Cord to oscillate fan head from side to
side while blowing air.
To adjust fan head vertically, pull Oscillating Cord to steady mode, then
loosen Tilt Adjustment Knob by turning counter-clockwise. Adjust fan
head upward or downward to desired angle then tighten Tilt Adjustment
Knob by turning clockwise.
WALL INSTALLATION
Drill hole into the wall then install provided hanging screw.
Hang fan unit into the wall. Make sure that the base plate of the fan is
properly fixed into the screw on the wall.
CLEAN AND CARE
Carefully wash movable parts of the Industrial Ground Fan with water and
mild detergent.
Avoid any kind of liquid to seep into the motor of the unit.
Avoid using harsh or abrasive cleaning materials when cleaning.
Wipe dry Industrial Ground Fan with a soft and dry cloth.
Put back parts and accessories of the Industrial Ground Fan to their
proper position before operating again.
SERVICE
Do not operate your KYOWA Wall Fan if the unit malfunctions or appears
damaged in any manner. Bring the complete product to the place of
purchase or to any authorized KYOWA dealers for inspection, repair or
replacement.
Do not disassemble your KYOWA Wall Fan by yourself. No user
serviceable parts inside. Refer all needed repair to an authorized KYOWA
service facility ONLY.
3
4