La Crosse Technology WT-2171 User manual

WT-2171
Radio-controlled Travel Alarm Clock
Table of Contents
Topic Page
Inventory of Contents 2
About WWVB 2
Program Mode
Initial Set-up 2
Manual Time Setting Option 3
Time Zone Setting 3
Daylight Savings Time (DST) 3
Display Mode Setting 3
Setting the Alarm 3
Operating the Alarm 3
Troubleshooting 4
Maintenance and Care 4
Specifications 4
Warranty Information 5

INVENTORY OF CONTENTS
1. The travel alarm
2. Instruction manual
3. Warranty card
ABOUT RADIO-CONTROLLED TIME - WWVB
The NIST (National Institute of Standards and Technology—Time and Frequency
Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact
time and date signal continuously throughout the United States at 60 kHz. The signal can
be received up to 2,000 miles away through the internal antenna in the alarm clock. Due
to the nature of the Earth’s Ionosphere, reception is very limited during daylight hours.
The alarm clock will search for a signal every night when reception is best. The WWVB
radio station derives its signal from the NIST Atomic clock in Boulder, Colorado. A
team of atomic physicists is continually measuring every second, of every day, to an
accuracy of ten billionths of a second per day. These physicists have created an
international standard, measuring a second as 9,192,631,770 vibrations of a Cesium-133
atom in a vacuum. More information on the atomic clock and WWVB can be found at
www.nist.gov.
PROGRAM MODE
Following is a list of steps to set up your new La Crosse Technology travel alarm clock.
• Please begin by removing the battery
cover on the rear of the travel alarm
shown in figure one.
• Next insert one AA alkaline battery
into the battery compartment making
sure to observe the correct polarity.
• When inserting the battery be sure n
to press any of the buttons on the
travel alarm as this will interrupt the
WWVB search and may cause the
travel alarm to not pick up the radio-controlled time signal.
ot
• Now replace the battery cover and face the travel alarm with the back of the unit
towards Colorado (this has been found to help the unit pick up the WWVB
signal).
• When the WWVB signal is received a tower icon will appear on the left side of
the LCD display.
Figure One
NOTE: Due to the nature of the WWVB signal it may take overnight for the travel alarm
to receive the signal and set. Adverse weather conditions may also affect the travel
alarms’ ability to receive the signal. In some cases it may take several nights for the
travel alarm to set.
2

Figure Two
Manual Time Setting Option (figure two)
• Press and hold the MODE/MIN button for 4 sec.
• Press and release the SNOOZE to display (flashing) time
• Press AL/HR to adjust the hour
• Press MODE/MIN to adjust the minutes
• Press and release the SNOOZE button twice to return to
the normal display mode
Setting the Time Zone and Daylight Savings Time
• Press and hold the MODE/MIN button for 4 sec.
• Set the time zone using the AL/HR button
• Set DST using the MODE/MIN button
• Press and release the SNOOZE button twice to return to the normal display mode
Display Mode Setting
The display below the time can be switched between showing the seconds and the alarm
time. To switch between these two modes press and release the “MODE/MIN” button.
Setting the Alarm
• Press and hold the AL/HR button for 4 sec.
• Press AL/HR to adjust the hour
• Press MODE/MIN to adjust the minutes
• Press and release the SNOOZE button twice to return to the normal display
mode
Operating the Alarm
• Press and release the AL/HR button
• When (((•))) appears the alarm is turned on
3

TROUBLESHOOTING
NOTE: For problems not solved, please contact La Crosse Technology via e-mail or
phone, or visit our website, www.lacrossetechnology.com
Problem: The time and date will not set initially.
Solution: It usually takes overnight before the clock can receive the signal due to the
interference the sun has on the WWVB signal. Wait overnight for the signal.
Solution: Computer monitors and televisions can cause interference with the signal
reception. Please keep the clock at least six feet from electrical sources.
Solution: In some areas of the US, in particular on the East and West coasts, the signal is
very weak. It may take up to 72 hours before a good signal is received. The
reception can be helped by placing the clock in a window facing Colorado,
with the back towards Colorado.
MAINTENANCE AND CARE INSTRUCTIONS
• Extreme temperatures, vibration, and shock should be avoided to prevent damage
to the unit.
• Clean displays and units with a soft, damp cloth. Do not use solvents or scouring
agents; they may mark the displays and casings.
• Do not submerge in water.
• Do not subject the units to unnecessary heat or cold by placing them in the oven
or freezer.
• Opening the casings invalidates the warranty. Do not try to repair the unit.
Contact La Crosse Technology repairs.
SPECIFICATIONS
Dimensions:
(L x W x H)
3” x 2” x 3.5”
(76x 50 x 89 mm)
Battery One AA Alkaline Battery
Battery life Approximately 1 year
4

5
WARRANTY INFORMATION
La Crosse Technology provides a 1-year warranty on this product. Contact La Crosse Technology
immediately upon discovery of any defects covered by this warranty.
Before sending the unit in for repairs, contact La Crosse Technology. The unit will be repaired or
replaced with the same or similar model.
This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty
batteries, or the units’ inability to receive a signal due to any source of interference.
LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL,
CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE
OPERATION OR MALFUNCTION OF THIS UNIT. THIS PRODUCT IS NOT TO BE USED
FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A
TOY. KEEP OUT OF CHILDRENS’ REACH.
This warranty gives you specific legal rights. You may also have other rights specific to your State.
Some States do not allow the exclusion of consequential or incidental damages; therefore the above
exclusion of limitation may not apply to you.
For warranty work, technical support, or information contact
La Crosse Technology
1116 South Oak Street
La Crescent, MN 55947
Phone: [phone]
Fax: [phone]
e-mail
[email protected]
(warranty work)
[email protected]
(information on other products)
Website
www.lacrossetechnology.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS:
1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or
duplicated or processed using electronic, mechanical or chemical procedures without written
permission of the publisher.
This handbook may contain mistakes and printing errors. The information in this handbook is
regularly checked and corrections made in the next issue. We accept no liability for technical
mistakes or printing errors, or their consequences.
All trademarks and patents are acknowledged.