La Crosse Technology 404-1220v2 User manual

20 INCH
ATOMIC WALL CLOCK
Model: 404-1220v2
DC: 010719
For information about WWVB, Atomic Time Signal visit: bit.ly/AtomicTime
• Always purchase the correct size and grade of battery most
suitable for intended use.
• Clean the battery contacts and also those of your clock prior to
battery installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from your clock when it is not used for an
extended period of time.
• Promptly remove an expired battery.
CARE AND MAINTENANCE
Battery Requirements: 1 AA (IEC LR6) required in movement
(Alkaline recommended)
Battery life: 12 months
SPECIFICATIONS
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from
date of purchase) on this product relating to manufacturing defects in
materials & workmanship.
Before returning a product, please contact our friendly customer
support with questions or visit our online help.
Phone: [phone]
Or fill out our online support request form here:
bit.ly/contact_techsupport
WARRANTY AND SUPPORT
Page | 1Page | 4
WARNING: This product can expose you to chemicals including styrene,
which is known in the State of California to cause cancer.
For more information go to: www.P65Warnings.ca.gov

POWER UP
1. Insert 1 AA battery into the Battery Compartment.
2. Firmly press the correct Time Zone Button.
3. For best reception, place your clock on a wall that faces
Ft. Collins, Colorado. During the night, your clock will set
itself.
IMPORTANT:
• Hands will move to 12:00, 4:00 or 8:00 and stay there
while the clock searches for the Atomic Time Signal. If not
received, your clock will continue to search for the WWVB
Atomic Time Signal every 2 hours until picked up.
• Allow up to 5 nights for the clock to receive the Atomic
Time Signal.
Note: Once the Atomic Time Signal is received, if the hour
is incorrect, hold your correct Time Zone Button until the
hands begin to spin. The clock will move to the correct time.
Manual Set Tab
Battery Compartment
Time Zone Buttons
Daylight Saving Time Button
(Default is DST ON)
Set Time:
1. Remove the battery for 15 minutes.
2. Insert battery and firmly press Time Zone Button.
3. When the hands stop spinning at 12:00, 4:00 or 8:00 hold
the Manual Set Tab until the correct time is achieved.
Note: The Atomic Time Signal will override your manual
settings if the signal is received.
4
3
2
1
MANUALLY SET TIME
• In certain areas, your clock may not be able to receive the
Atomic Time Signal due to signal strength or interference.
• In this case, your clock can be set manually and operate
as a quartz clock until the WWVB signal can be received.
Follow us on our social media outlets for the latest
promotions, product support, and awesome giveaways.
LET’S BE SOCIAL!
Page | 3Page | 2
PT MT CT ET
AA
4
3
2
1