La Crosse Technology WT-3161BKx1 User manual

16” ATOMIC WALL CLOCK
Model: WT-3161BKx1
DC: 111219
For information about WWVB, Atomic Time Signal visit: bit.ly/AtomicTime
• Always purchase the correct size and grade of battery most suitable
for intended use.
• Clean the battery contacts and also those of your clock prior to battery
installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from your clock when it is not used for an extended
period of time.
• Promptly remove an expired battery.
CARE AND MAINTENANCE
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from
date of purchase) on this product relating to manufacturing defects in
materials & workmanship.
Before returning a product, please contact our friendly customer
support with questions or visit our online help.
Phone: [phone]
Or fill out our online support request form here:
bit.ly/contact_techsupport
La Crosse Technology, Ltd.
2830 South 26th St.
La Crosse, WI 54601
WARRANTY AND SUPPORT
Page | 1Page | 4
WARNING: This product can expose you to chemicals including styrene,
which is known in the State of California to cause cancer.
For more information go to: www.P65Warnings.ca.gov

POWER UP
1. Select Time Zone and DST ON or OFF.
2. Insert 1 AA battery into the Center Battery Compartment.
Optional: Insert 2 AA batteries into the Extra Battery
Compartments for an extended 3 year battery life.
IMPORTANT: Be sure all batteries are of the same voltage level.
3. The hands will move to the 12 o’clock position and search for
the WWVB Atomic Time Signal for up to 8 minutes.
• If no signal, after 8-10 minutes, clock will run from 12:00.
• Clock will continue to search for the WWVB Atomic Time
Signal. Allow up to 5 nights for the clock to receive this
transmission.
4. For the best reception, place the clock on an exterior wall near
a window with the front or back of it facing Fort Collins, CO.
Watch the setup video: bit.ly/wallclock_setup
Note: In certain areas, this clock may not be able to receive the
WWVB reception due to signal strength or interference. In this case,
your clock can be set manually until the Atomic Time Signal can be
received.
6
5
SET
RESET
WAVE (Atomic search)
Center Battery Compartment
Time Zone Selector
Daylight Saving Time Selector
4
3
2
1
Page | 3Page | 2
7
6
5
4
3
2
1
AA
+
-
AA
+
-
7
7Optional:
Extra Battery Compartments
Set Time:
1. Hold SET for 3 seconds to manually set your time.
• Press and hold SET again to move hands quickly.
• Press and release SET to move hands forward step by step.
Note: The Atomic Time Signal will override your manual setting if
the transmission is received in the future.
MANUAL SET TIME
Ask questions, watch detailed setup videos, and provide
feedback on our social media outlets!
LET’S BE SOCIAL!
• If the clock does not respond when trying to manually set your
time, press the RESET button one time.
• The hands will move to the 12 o’clock position and begin
searching for the WWVB Signal again.
RESET BUTTON
Battery Requirements: 1 AA (IEC LR6) required in the Center Battery
Compartment (Alkaline recommended)
Optional: 2 Extra AA batteries
Battery life: 1 battery: 12 months / 3 batteries: up to 36 months
SPECIFICATIONS