La Crosse Technology WT-3122A User manual

For information about WWVB, Atomic Time Signal visit: bit.ly/AtomicTime
Page | 1Page | 4
• Always purchase the correct size and grade of battery most
suitable for intended use.
• Clean the battery contacts and also those of your clock prior to
battery installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from your clock when it is not used for an
extended period of time.
• Promptly remove an expired battery.
CARE AND MAINTENANCE
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from
date of purchase) on this product relating to manufacturing defects in
materials & workmanship.
Before returning a product, please contact our friendly customer
support with questions or visit our online help.
Phone: [phone]
Or fill out our online support request form here:
bit.ly/contact_techsupport
La Crosse Technology
2830 South 26th St.
La Crosse, WI 54601
WARRANTY AND SUPPORT
WARNING: This product can expose you to chemicals including
styrene, which is known in the State of California to cause cancer.
For more information go to: www.P65Warnings.ca.gov
12.5 INCH
ATOMIC WALL CLOCK
Model: WT-3122A
DC: 021020

POWER UP
1. The hands will move to the 4, 8, or 12 o’clock position and stay
there while it searches for the WWVB Atomic Time Signal. Allow
up to 5 nights for the clock to receive this transmission.
2. For the best reception, place the clock on an exterior wall near a
window with the front or back of it facing Fort Collins, CO.
3. Once the Atomic Time Signal is received, the clock will set to
Pacific Time. Firmly press and hold your correct Time Zone Button
until the hands begin to spin. The time will then set correctly.
4. If you live in an area that does not follow Daylight Saving Time,
while the hands are spinning to the correct time, press the
Daylight Saving Time Button once to turn the DST setting to OFF.
Watch the setup video: bit.ly/wallclock_setup
Note: In certain areas, this clock may not be able to receive the
WWVB reception due to signal strength or interference. In this case,
your clock can be set manually until the Atomic Time Signal can be
received.
Manual Set Tab
Center Battery
Time Zone Buttons
Daylight Saving Time Button
(Default is DST ON)
1. Remove all batteries from the clock.
2. Press the Manual Set Tab at least 20 times and wait 15 minutes.
3. Insert at least one battery into the Center Battery Compartment.
4. Allow the hands to spin around and stop in either the 4, 8, or 12
o’clock position.
5. Hold the Manual Set Tab until your correct time is achieved.
Note: The Atomic Time Signal will override your manual setting if
the WWVB transmission is received in the future.
4
3
2
1
MANUALLY SET TIME
Ask questions, watch detailed setup videos, and provide feedback
on our social media outlets!
LET’S BE SOCIAL!
Page | 3Page | 2
Battery Requirements: 1 AA (IEC LR6) required in movement
(sold separately)
Battery Life: 1 Battery - 12 months
SPECIFICATIONS
PT MT CT ET
AA
4
3
2
1