LACOSTE WATCHES
Operating instructions – digital models
A
BC
D
PM Time
Indicator
Dual-Time
Mode Indicator Time in Second
Zone: HH:MM
Figure D – DUAL-TIME Mode
LEGEND
A– EL Backlight/Reset Button
B– Mode Selection Button
C – Setting Mode Button
D – Start/Stop Button
___________________________________________________
To set TIME in Second Time Zone:
1. From Dual-Time Operating Mode, press Cto enter DUAL-TIME
Setting Mode. Active field will blink.
2. Press Dto adjust HOURS; then press Bto advance.
3. Press Dto adjust MINUTES; then press B to advance.
4. Press Cto confirm settings and return to Dual-Time Operating Mode.
A
BC
D
Countdown
Timer Settings
Countdown
Mode Indicator
Current Time
in 24H Format:
HH:MM
Countdown
ON Indicator
Figure E – COUNTDOWN Mode
LEGEND
A– EL Backlight/Reset Button
B– Mode Selection Button
C – Setting Mode Button
D – Start/Stop Button
___________________________________________________
To operate COUNTDOWN timer:
1. In Countdown Operating Mode, press Dto start/stop countdown.
2. When Countdown stops, press Ato return display to preset time.
NOTE: When Countdown timer reaches 0, it stops automatically and
Alarm rings for 10 seconds. Press any button to stop Alarm.
To set COUNTDOWN duration:
1. From Countdown Operating Mode, press Cto enter COUNTDOWN
Setting Mode.
2. Press B to advance through COUNTDOWN Setting Sequence:
HOUR →MINUTES →SECONDS. Active field will blink.
3. Press D to adjust the blinking number in each active field; then press
Bto advance.
4. Press Ato turn Countdown ON or OFF; when activated,
appears beneath Seconds in the Main digital display.
5. Press C to confirm settings and return to Countdown Operating Mode.
A
BC
D
Split Time
Indicator
Stopwatch
Mode Indicator
Figure F – STOPWATCH Mode
LEGEND
A– EL Backlight/Reset Button
B– Mode Selection Button
C – Setting Mode Button
D – Start/Stop Button
___________________________________________________
In STOPWATCH Mode, this watch functions like a chronograph to
measure intervals of time. Use Buttons Aand Dto operate the
stopwatch timer.
To operate STOPWATCH:
1. Press Dto start timing.
2. Press Da second time to stop timing; read elapsed time on Main
digital display.
3. Press Ato reset display to zero.
To take a SPLIT-TIME reading:
1. Press Dto start timing.
2. Press Ato read split time in Main digital display; appears
beneath Seconds in Main digital display.
3. Press Aagain to resume timing.
4. Repeat steps 2 and 3 to take any additional split times.
5. Press Dto stop timing.
6. Press Ato reset display to zero.
