Lagooni JUNIOR XS User manual

MANUAL
BACKREST ADJUSTMENTFOOTREST ADJUSTMENT ARMRESTSBRAKES
Loosen the knobs both left and right from
the backrest.
Unscrew the bolts with an Allan key nr. 4
and a spanner nr. 10.
Adjust the backrest to a desired position
and tighten the knobs again.
Place the footrest in the desired position
and screw it tight again.
Slightly lift the armrests to swivel them
around. When placing them back, make
sure the armrests wil be tightened by
pushing them down well enough.
The brakes can be locked or unlocked
by pushing or pulling. The brakes can be
tighten when needed by using an Allan
key nr. 5.
TRANSPORT
Remove the armrests by lifting them out
of their position.
Press the quick-release axle of the wheel
to remove the wheel. Remove the axles
from the wheel before transport, to insure
they don’t bend.
Loosen the knobs of the backrest (left and
right) and lay the backrest down.
Remove the backrest from the receivers.
The backrest has to be turned. The bend
is directed downwards. Replace the back-
rest and thighten the knobs.

MANUAL
MAINTENANCE
aRemove soap and dirt regularly by
using a soft soap. Do not use any
caustics like chlorine or alcohol. It
is possible to clean the frame with
Antikal.
aSpray the quick release axles of
the wheels with silicone spray once in
every three months.
aSpray the quick-release pins of the
seat and backrest with silicone spray
once in every three months.
aNeoprene and Platilon are comfor-
table but sensitive materials.
Be careful with sharp objects like zip-
pers, lifts, etc.
aReplace the seat over time.
Normally, but depending on the
frequency and intensity of the use, it
can be used for 3 years. After 3 years,
Neoprene and Platilon become porous
and water soaks into the underlying
polyether.
IMPORTANT WITH TRANSPORT
aKeep the quick release axles
pressed while removing or
replacing the wheels. If not: the
bearings can be pushed out and
the wheel can’t be replaced.
aIf the wheel is not positioned
properly, the bearing is probably
slightly pushed out (the deviation
is often slight, but can have a big
impact). Tap with a hammer (or
other heavy object) on the bearing
in the wheel. The bearing will be
repositioned and the wheel can be
replaced properly.
Lagooni BV - Vlotlaan 4a - 2681 RX Monster - The Netherlands - Telephone (+31) (0)174-281551 - [email protected]om - www.lagooni.com