Tips to make your coolers best performance:
1. Pre-chilling. Treat your cooler as a temperature maintainer. Now that you think about it in this
way, you can understand why it is so important to bring the internal temperature of the cooler
down before adding ice. This process is referred to as pre-chilling and is essential for the
proper operation of your cooler. We recommend placing dry ice in the cooler for at least 1
hour. Aways use proper safety precautions when handling dry ice including the use of
gloves. If dry ice is not available place the cooler in a chest freezer overnight. Another option
is to fill up the cooler with ice and leave overnight, then change to fresh ice before using.
2. If possible, chill or freeze any goods before placing them in the cooler. The ice will last much
longer.
3. Water from melted ice is not a bad thing! Cold water that comes from ice after a few days
helps insulate the remaining ice better than empty airspace.
4. Open your lid as few times as possible to reduce warm air coming from the outside. Always
shut the lid with latch lock in correct position after you opened the cooler.
5. Ice performance can vary greatly. Block ice will melt slower than cube ice, but cube ice with
a larger total surface area will cool items faster. You may want to consider a mixture of both
types. Start with very cold, solid ice versus wet ice that has already begun to met. Besides,
the temperature, times you open the lid, will also influence the ice performance too.
6. Fill cooler with as much ice as possible.
7. Your cooler is dry ice approved. Dry ice (CO2), made from frozen carbon dioxide, is an
excellent way to achieve super cold temperature, without any water residue. Always handle
dry ice with caution and wear protective gloves, as it can quickly freeze burn skin (-109°F).
Allow for adequate ventilation of any CO2gas. It may be helpful to add some dry ice to your
ice mixture to keep it colder longer.
WARNING: Dry ice may explode in an airtight container, loose the plug button
before you put dry ice into cooler.
E2
PRODUCT INTRODUCTION TECHNICAL DETAILS
HEAVY DUTY RUBBER
LATCHES
NEVER CHANGE THOSE PLASTIC
BRACKET EVER AGAIN!
NON-SLIP BOTTOMS
KEEP YOUR COOLER IN PLACE
HEAVY DUTY HANDLES
ULTRA STRENGTH POLYESTER ROPE
QUICK DRAIN SYSTEM
LEAK-FREE EASY DRAIN FLOW SPOUTS
NEVER-BREAK HINGE SYSTEM
INTERCONNECTED DURAL STAINLESS STEEL
HINGES
FREEZER-GRADE RUBBER GASKET
TIGHT SEAL BLOCKS OUT THE HEAT.
LOCKS THE COLD INSIDE
ROTOMOLDED CONSTRUCTION
VIRTUALLY INDESTRUCTIBLE
SAFER TIE-DOWN SLOTS
KEEP IT IN PLACE REGARDLESS OF THE
ACTIVITY YOU ARE PERFORMING
