STB-6000
USER MANUAL
•
Read all instructions carefully before use.
•
Retain manuals for future reference.
•
Use this product only in the manner described.
•
Only use a water-dampened soft-cloth to clean the surface of this product.
•
Use electronic devices in well ventilated areas & not exposed to excess vibration.
•
The following will damage this product: any liquid such as water or moisture, extreme heat,
cold, humidity, dusty or sandy environments.
•
Disconnect this product from mains power and antenna during lightning storms.
•
Only place this device on stable surfaces and ensure that any attached cables are secure and
will not cause the device to fall.
•
There are no user serviceable parts in this product.
•
Un-authorized attempts to dismantle or repair this product will void product warranty and
may result in dangerous electric shock.
•
Remove any power or data cords by pulling them from the plug and not the cord.
•
Using this device near other electronic devices may cause interference.
•
When recording images or video using this product please be respectful or the
•
Copyright requirements and restrictions as they apply to each program in your area.
•
Images shown in this document are for references only and there may be differences between
images and actual products.
•
Do not mix old and new batteries in the remote.
•
We reserve the right to change the products and/or documentation without notice.
1 x STB-6000 HD Set Top Box
1 x Remote control
1 x AV Cable (Composite RCA)
1 x User Manual (This Document)
1.
Remove the battery compartment cover on the rear of the Remote control.
2.
Insert the
2
X AAA batteries (supplied) in to the compartment being sure to match the polarities
with the markings in the compartment.
3.
Fit the cover back on the remote control and make sure that it locks in place.
1.0pen the cover
2.Install batteries
3.Close the cover
Note: Please do not mix old and new batteries in this remote. Remove batteries if
remote is not going to be used for long periods.
4
