Laserworld CS-300 G User manual

CS-300 G
~300mW green club laser
USER MANUAL
Please read this manual carefully bef re y u initially start-up!

USER MANUAL: Laserworld CS-300 G 300mW green club laser
Date: 01/2008
Page
2
of
9
Table f c ntents
Page
1. SAFETY INSTRUCTIONS 3
2. OPERATING DETERMINATIONS 4
3. SOUND-MODE 5
4. OPERATION WITH DMX 5
5. DMX CHANNELS 6-7
6. TECHNICAL SPECIFICATIONS 8
7. MAINTENANCE 8
Checking Parts
Please check if the following parts are included:
1 x CS-300 G Laser
1 x Power cable
1 x User manual

USER MANUAL: Laserworld CS-300 G 300mW green club laser
Date: 01/2008
Page
3
of
9
DANGER LASER RADIATION!
Avoid direct eye exposure!
Laser radiation can cause eye damage and/or skin damage
All protective measures for a safe operation of this laser must be applied.
1. SAFETY INSTRUCTIONS
- If the device has been exposed to drastic temperature fluctuation, do not
switch it on immediately. The arising condensation water might damage your
device. Leave the device switched off until it has reached room temperature.
-The laser must only be used for shows. The operation is only allowed if it is
controlled by a skilled and well-trained operator.
- Never leave this device running unattended and keep it away from children
and amateurs.
-Keep away from heaters and other heating sources. In order to safeguard
sufficient ventilation, leave 50 cm of free space around the device.
-Never direct the laser beam to people or animals.
-CAUTION LASER DIODE: Never unscrew the housing!
There are no serviceable parts inside the device. Maintenance and service
operations are only to be carried out by authorized dealers.
-Always disconnect from the mains when the device is not in use or before
cleaning it.
- HEALT HAZARD! Never l k directly int the light s urce, as sensitive
pers ns may suffer an epileptic sh ck!

USER MANUAL: Laserworld CS-300 G 300mW green club laser
Date: 01/2008
Page
4
of
9
2. OPERATING DETERMINATIONS
-The operator has to make sure that laser radiation also reflected laser
radiation higher than the highest allowed level is avoided by technical or
organisational measures.
-Make sure that the used voltage is : AC 220V~240V, 50/60Hz
-If the device is used in a flying installation, the mounting brackets and an
appropriate safety-rope must be fixed.
-Laser effects are not designed for permanent operation. Consistent operation
breaks will ensure that the device will serve you for a long time without
defects.
-In some country, the operator must notify the accidence insurance and the
authority for industrial safety, before operating a laser. For more information,
contact the relevant authorities.
-Please consider that unauthorized modifications on the device are forbidden
due to safety reasons!
-If this device will be operated in any way different to the one described in this
manual, the product may suffer damages and the guarantee becomes void.
Furthermore, any other operation may lead to dangers like short-circuit,
burns, electric shock, etc.

USER MANUAL: Laserworld CS-300 G 300mW green club laser
Date: 01/2008
Page
5
of
9
3. CONTROL BOARD INSTRUCTION
For sound-mode the 10
th
DIP-switch at the back of the unit must be “ON”.
4. OPERATION WITH DMX
Set the DMX address code with the binary system “0” or “1” remind that the 10
th
Dip switch is “OFF” for DMX mode.
Examples:
DMX-
address
DMX-
address
1 65
17 113
33 161
The device has 16 operate channels, so if you set the first on DMX address “1”
The second should be DMX address “17” and so on.

USER MANUAL: Laserworld CS-300 G 300mW green club laser
Date: 01/2008
Page
6
of
9
5. DMX CHANNELS
The CS-300 G is able to show 2 patterns at the same time. In this
manual they are called pattern “A” and “B”.
DMX Channel DMX-Value Descripti ns
1
M de
pattern A
0 –
51
52 – 103
104 – 155
156 – 207
208 - 255
N Output
N rmal pattern
p inted pattern
pattern with s und-m vement
p inted pattern with s und-
m vement
2
pattern A
0-255 Lines,waves,circles and Graphics
3
r tati n A
0 – 128
129 - 255
R tati n angle A
R tati n speed A
4
X-turning A
0 – 128
129 - 255
X-p siti n A
X-speed A
5
Y-turning A
0 – 128
129 - 255
Y- p siti n A
Y- speed A
6
m vement A
0 – 128
129 - 255
H riz ntal speed A
Vertical speed A
7 0 - 255 Drawing speed A
8 0 - 255 P int lenght A
9
M de
pattern B
0 –
51
52 – 103
104 – 155
156 – 207
208 - 255
N Output
N rmal pattern
p inted pattern
pattern with s und-m vement
p inted pattern with s und-
m vement

USER MANUAL: Laserworld CS-300 G 300mW green club laser
Date: 01/2008
Page
7
of
9
10
pattern B
0-255 Lines,waves,circles and Graphics
11
r tati n B
0 – 128
129 - 255
R tati n angle B
R tati n speed B
12
X-turning B
0 – 128
129 - 255
X-p siti n B
X-speed B
13
Y-turning B
0 – 128
129 - 255
Y- p siti n B
Y- speed B
14
m vement B
0 – 128
129 - 255
H riz ntal speed B
Vertical speed B
15 0 - 255 Drawing speed B
16 0 - 255 P int lenght B

USER MANUAL: Laserworld CS-300 G 300mW green club laser
Date: 01/2008
Page
8
of
9
6. TECHNICAL SPECIFICATIONS
P wer supply: AC 220V-240V, 50/60 Hz
X/Y ptical angle: +/- 30°
Scan speed: 20kpps.
DMX 512: 16 channels
Ambient temperature: -10°C +35°C
P wer c nsumpti n: 120 W
W rking m de: music active, DMX512
Optical p wer: green: ~300mW / 532nm
Laser classificati n: 3b
P wer fuse: 250V/2A Ф5x20mm
Weight: 10 kg
Dimensi ns: 50 x 24 x 18 cm
7. MAINTENANCE
Maintenance should be preformed every 15-day period, by using a sponge which is
dipped with alcohol, rather than wet cloth or other chemical liquid, to clean the
mirror.
Always disconnect from the mains when the device is not in use or before cleaning it.
There are no serviceable parts inside the device. Maintenance and service operations
are only to be carried out by authorized dealers.
Never l k directly int the light s urce.
Always disc nnect fr m the mains when the device is n t in use r bef re
cleaning it.
This device has left our premises in absolutely perfect condition. In order to maintain
this condition and to ensure a safe operation, it is absolutely necessary for the user
to follow the safety instructions and warning notes written in this user manual.
Laserworld cannot be made liable for damages caused by incorrect installations and
unskilled operation!

USER MANUAL: Laserworld CS-300 G 300mW green club laser
Date: 01/2008
Page
9
of
9
EU- Declarati n f C nf rmity
We hereby confirm that the following device
Laserw rld CS-300 G – 300mW green club Laser
complies with the essential safety requirements, laid down in the regulations of the
committee to assimilate the provisions of law of all participating EU states on the
electromagnetic compatibility (89/446/EWG).
The device has been classified considering the following EU-norms on
electromagnetic compatibility:
DIN EN 55103-1: 1996
DIN EN 55103-2: 1996
DIN EN 61000-3-2:2000 + A2: 2005
DIN EN 61000-3-3:1995 + A1: 2001
Assessment of compliance of the product with the requirements relating to the Low Voltage
Directive (LVD) was based on the following standards:
DIN EN 60065 : 2002
Furthermore, the device is verified in correspondence to the laser class
regulations DIN EN 60825-1, if properly set up according to the upper
mentioned laser safety regulation.
After installing the device, an inspection and official approval is indispensable for the overall
setup. The inspection must follow the european guidelines EN 60825-1 and corresponding
regulations for the prevention of accidents BGV-B2. This declaration is executed on behalf of
the CS-200G ECO Laser manufacturer
Laserworld e. K.
Tannenweg 11-19
71134 Aidlingen / DE
Represented by
Martin Werner
President
Aidlingen, 01.06.2006
Laserworld (Switzerland) AG
based in:
Rheinblick Residenz
Oberstrasse 1
8274 Tägerwilen
SWITZERLAND
Authorized person:
Supervisory board Ms Rhea Gössel
place of business: 8274 Tägerwilen / Schweiz
company number: CH-440.3.020.548-6
Commercial Registry Kanton Thurgau
www.laserworld.com
[email protected]
Laserworld (Switzerland) AG
c/o LOG.ON GmbH
Raiffeisenstrasse 8
78658 Zimmern ob Rottweil
GERMANY
VAT number: DE252331844
WEEE-Reg.-Nr.: DE 93014361