© Learning Resources, Inc., Vernon Hills, IL (U.S.A.)
Learning Resources Ltd., King’s Lynn, Norfolk (U.K.)
Please retain our address for future reference.
Made in China. LRM3774-GUD
Fabriqué en Chine. Informations à conserver.
Made in China. Bitte bewahren Sie unsere
Adresse für spätere
Nachfragen auf.
Hecho en China. Conservar estos datos.
Visit our website to write a product review
or to find a store near you.
Battery Information
Installing or Replacing Batteries
WARNING! To avoid batte y leakage, please follow these inst uctions ca efully. Failu e to
follow these inst uctions can esult in batte y acid leakage that may cause bu ns,
pe sonal inju y, and p ope ty damage.
Requi es: 2 x 1.5V AAA batteries and a Phillips screwdriver
• Batteries should be installed or replaced by an adult.
• Answer Buzzers require (2) two AAA batteries each.
• he battery compartment is located on the bottom of the unit.
• o install battery, first undo the screw with a Phillips screwdriver and remove the
battery-compartment door. Install batteries as indicated inside the compartment.
• Replace compartment door and secure with screw.
Battery Care and Maintenance Tips
• Use (2) two AAA batteries.
• Be sure to insert batteries correctly (with adult supervision) and always follow
the toy and battery manufacturer’s instructions.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries.
• Do not mix new and used batteries.
• Insert batteries with the correct polarity. Positive (+) and negative (-) ends must be
inserted in the correct directions as indicated inside the battery compartment.
• Do not recharge non-rechargeable batteries.
• Only charge rechargeable batteries under adult supervision.
• Remove rechargeable batteries from the toy before charging.
• Only use batteries of the same or equivalent type.
• Do not short-circuit the supply terminals.
• Always remove weak or dead batteries from the product.
• Remove batteries if product will be stored for an extended period of time.
• Store at room temperature.
• o clean, wipe the surface of the unit with a dry cloth.
• Please retain these instructions for future reference.
Information to User
NOTE: This equipment has been tested and found to comp y within the imits for a C ass B digita device, pursuant to Part
15 of the FCC Ru es. These imits are designed to provide reasonab e protection against harmfu interference in a
residentia insta ation.
This equipment generates, uses, and can radiate radio frequency energy and if not insta ed and used in accordance with
the instructions, may cause harmfu interference to radio communications. However, there is no guarantee that interference
wi not occur in a particu ar insta ation. If this equipment does cause harmfu interference to radio or te evision reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the fo owing measures:
-Reorient or re ocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an out et on a circuit different from that to which the receiver is connected.
-Consu t the dea er or experienced radio/TV technician for he p.
NOTE: Changes or modifications not express y approved by the party for comp iance cou d void the user’s authority to
operate the equipment.