LEDS C4 71-7666-00-00 User manual

S1 S2 S3 S4
71-7666-00-00 — Wall Controller / DMX
—Function introduction
Front side
←
Output Signal DMX512 signal
Power Supply 100-240VAC
Power consumption 15 mA
Operating temperature 0-40˚ C
Relative humidity 8% to 80%
Dimensions 86 × 86 × 29.1 mm
Waterproof grade IP20
Important: Read All Instructions Prior to Installation
Press and hold down to save color/effect. Click to recall the saved colors/scenes.
R/G/B/W 4 channels: Cick to turn off/on the channel.
Press and hold down to increase light intensity of each chanel.
LED indicator
Click to switch ON/OFF
Press and hold down to
increase/decrease light intensity
Click to play / pause the
10 built-in effects.
Press and hold down to
speed up/down the
running effects.
Touch color wheel,
touch to select R/G/B
color
—Product Data
—Safety & Warnings
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
—Wiring Diagram
LEDS C4 S.A. - Afores s/n 25750 Torà. Lleida (Spain). [phone] leds-c4.com
Back side
←
Lateral side
←
• Touch sensitive.
• Control RGBW color.
• Control 1 zone/area.
• Enable to save 4 scenes.
59.00 mm
59.00 mm
Wall Controller / DMX
DMX512 signal output AC Power input
31.20 mm
Power
Supply
Wall Controller /
DMX
DMX Receiver
DMX Receiver
DMX Receiver

Set DMX Address
This DMX master controller controls 4 zones of DMX decoders by setting DMX decoders’ address as follows:
DMX decoders with adress 001 will be controlled by zone 1,
DMX decoders with adress 005 will be controlled by zone 2,
DMX decoders with adress 009 will be controlled by zone 3,
DMX decoders with adress 013 will be controlled by zone 4.
Save color/scene/mode:
Recall the saved colors/scenes:
LEDS C4 S.A. - Afores s/n 25750 Torà. Lleida (Spain). [phone] leds-c4.com
Turn on the wall
panel controller
Click on of the
zone numbers
Operation the buttons to
select a color/mode you like
Turn on the wall
panel controller
Click on of the zone
numbers you would like
to recall the scene/color
Click button S
Immediately click any number of 1-4 (here
the numbers mean 4 scenes can be saved
for the selected zone) to save scene
Click any number of 1-4 (here the
numbers mean 4 scenes saved for
the selected zone) to recall a
saved scene
The connected LED light with DMX
decoder/RF receiver will flash
The color/scene is
saved successfully
Press and hold down button Suntil
the LED indicator change color