LEERS L1 User manual

Vacuum module maintenance tool

Product Parameters
Model
L1
L1 AC
L2
L2 AC
Sucker
Face
Dimension
134X134mm
134X194mm
Available
Module
Size
134X134 to 192X192mm
Size modules
192X192 to 500X500mm
Size modules
Product
Dimension
152X140X210mm
L1 152X140X210mm
Adapter 195X100X46mm
152X140X210mm
L2 152X140X210mm
Adapter 195X100X46mm
Weight
1.17kg
2.69kg
1.17kg
2.69kg
Working
Duration
17m
Continuous
17m
Continuous
Working
Temperatur
e
3-55℃
1
L1
L2
3 meters
IN:AC100-240V-OUT:DC24V
(L1 AC/L2 AC Use )

Function description
Lanyard ring
It’s used to fix the lanyard ,and with it more easy to carry during use.
Regulating valve
The rotation of the regulating valve will leak out of the elliptical air inlet hole, and
more air intake hole leaks, the suction force will go smaller. The sucker has the
largest suction force when the hole is fully covered. This function can be used to
adjust the suction force.
LED module contact silicone
Soft silicone contacts with the module surface to protect the lamps.
Power display
This is used to show the battery status. If the power switch is turned on, and no
display, it means the battery is empty and need recharge.
Power switch
Power supply main switch.
Start button
Start and pause control of the device, you need to turn on the power switch before
use it.
Battery removal button
The battery can be pulled out with pressing the button.
Charging port
Battery charging interface.2

1. Turn on the power switch.
2. Press the start button
and the device will starts.
3. Put the device flat onto
the surface of the LED
module which you want
to take off, make sure the
device is tightly sucked
with the module.
4. Pull out the device and
module vertically.
Instructions
3

other instructions
Charger
1. Input AC100-240V 50/60 Hz 0.6A.
2. The charger indicator light red
means charging and green means
the battery is full.
3. Note: Please use the charger
provided by the manufacturer.
1. In addition to the battery, the equipment is repaired free of charge
within one year.
2. The battery is a lossy part, it is not covered by the warranty.
3. Man-made damage, dis-assembly, water ingress, drop, charging
with a non-configured charger. Will be paid for repairs.
Warranty description
Charging instructions
1.If it is a COB module or module with pitch 1.5 mm or less, it is
recommended to fully open the regulating valve. Effectively reducing
the working pressure of the motor can extend the life of the product.
2. If the motor is hot for a long time use, the equipment can be idling
and the electric machine can cool down quickly.
3. When the LED module is repaired, pull it out with a vertical force
to avoid the lamp damage.
skills
1. Press the battery
removal button.
2. Hold the battery
tightly, and pull it out.
3. Push the battery that
needs to be replaced to
the card slot and push it
up to the end. After the
battery is in place, it cannot be pulled out directly.
Battery replacement
4

A f t e r - s a l e s e r v i c e