HOW TO ASSEMBLECLEANING
1. Before first use
a. Disassemble all parts
b. Wash in warm soapy water (except for the tubing)
c. Rinse well with clean water
d. Submerge parts in pot of water (except for tubing) and boil for
3-5 minutes
i. Use large pot to prevent parts from touching sides or bottom of pot
e. Shake off excess water and air-dry on a dedicated rack or clean cloth
2. After each use
a. Put aside parts that don't come in contact with breastmilk
i. When used correctly, tubing does not come in contact with
breastmilk and does not need to be cleaned
b. Disassemble all other parts (silicone cushion, silicone diaphragm,
cap and bottle)
c. Rinse with cold water soon after use
d. Wash in warm soapy water
i. The silicone cushion can be cleaned by gently rubbing between fingers
e. Rinse well
f. Shake off excess water and air-dry on a dedicated rack or clean cloth
3. How to sanitize
a. Follow cleaning instructions 2.a through 2.e
b. Submerge parts in pot of water and boil for 3-5 minutes
i. Use large pot to prevent parts from touching sides or bottom of pot
c. Shake off excess water and air-dry on a dedicated rack or clean cloth
*After first sanitizing all parts (except tubing), please do not boil silicone
parts again. Do not steam sterilize or dishwash silicone parts. Handwash
only after first use.
1) Assembling the breastshield kit:
Insert the soft silicone cushion into the
breast shield. Ensure the valve is
securely attached to the bottom of the
breast shield.
2) Assembling the diaphragm:
Press the silicone diaphragm down with
your fingers so it's flush with the top of
the breast shield. Place the white cap on
with the hole for the tubing insert
positioned slightly to the right. Twist the
cap to the left until it's tightly in place.
3) Assembling the bottle and the base:
Twist the bottle on and insert the tubing into the white cap.
4) Attaching the tubing:
Insert the tubing connectors (07) to
both end of tubing (06).
6 7
