LEGO Lamborghin Sian FKP 37 User manual

Power Functions for Lamborghini Sián FKP 37 #42115
only applicable to LEGO lambo or lambo with the same instructions
please read carefully and continue to assemble and modify according to the following tutorial
1. The color of some accessories may be different from that of the tutorial, please follow the actual
object.
2. Remember to recheck each step after assembly, and the orientation of the cross shaft gear
spacing shall be well controlled.
3. Remember not to twist the linkage at will during assembly, and carefully recheck whether each step
is completed correctly.
4. The step number below is paragraph oriented, and it can be assembled in sequence without paying
attention to the sequence number arrangement of the steps.
https://editor.foxitsoftware.cn?MD=shanchu

Continue to assemble according to instructions 9-12, and change a gear in step 13
Continue to assemble according to the instructions 14-44, and the changes
required in step 45 are as follows:
This gear needs changing
https://editor.foxitsoftware.cn?MD=shanchu

6
7

3

Continue assembly of 12
https://editor.foxitsoftware.cn?MD=shanchu
Gear flush with motor hole

The following step number can be ignored an
can be assembled in sequence
Assemble it here, stack and install the motor wire head on the lithium
battery to test whether it can rotate normally, and then continue to
assemble
https://editor.foxitsoftware.cn?MD=shanchu

X
X
√√
○
继续此21的拼装
Link the two parts together!
Follow the above tutorial to install without change.But There are 2 errors in the
following electronic pictures. Electronic pictures need be ignored here.
Please pay attention to 2 "X" points
1.Red differential cancelled in the following steps. Refer to the above figure
2. Gray differential lock direction shall be follow the actual picture, and the
electronic picture is in the wrong direction)
https://editor.foxitsoftware.cn?MD=shanchu